MTCBA-C1-N16 Multi-Tech Systems, MTCBA-C1-N16 Datasheet - Page 78

no-image

MTCBA-C1-N16

Manufacturer Part Number
MTCBA-C1-N16
Description
MODEM ETHERNET
Manufacturer
Multi-Tech Systems
Datasheets

Specifications of MTCBA-C1-N16

Function
Transceiver, CDMA, Modem
Modulation Or Protocol
CDMA2000
Frequency
800MHz, 1.9GHz
Applications
Aeris Networks (USA)
Interface
RS-232
Data Rate - Maximum
153.6 kbps
Voltage - Supply
9 V ~ 32 V
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
Q4976016

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MTCBA-C1-N16
Manufacturer:
Multi-Tech Systems
Quantity:
135
SMS Message Storage Full +WMGF
Description:
Syntax:
SMS Read Acknowledge Enable +WSRA
Description:
Syntax:
Values:
Multi-Tech Systems, Inc. CDMA C1 AT Commands Reference Guide (PN S000478C)
This response indicates that the SMS Service Center has attempted to send an SMS message
but it was rejected because SMS Message Storage is Full. No new SMS messages will be
received until some room is created by deleting old messages from SMS storage. Message
deletion can be done using AT+CMGD.
Response Syntax: +WMGF
This command enables or disables sending an SMS to acknowledge the reading of an MT SMS.
If enabled, a point-to-point SMS will be sent back to the origination address of the MT SMS when
the SMS is read using AT+CMGR command. The message type contained in the Message ID
Bearer for the SMS is Read Acknowledge.
This setting is saved in non-volatile memory. It is also restored to the default value by the restore
to factory defaults command, AT&F.
Command Syntax: AT+WSRA=[<val>]
<val>
Example Result
+WMGF
Note: Incoming message rejected. Message center notified with “out of resources” message.
Message center will attempt to re-send the message at a later time.
Command
AT+WSRA
AT+WSRA=1
AT+WSRA?
Note: Current value
AT+WSRA=?
0
1
SMS Read Acknowledge capability is disabled (Default)
SMS Read Acknowledge capability is enabled
General Codes
32768
32770
32771
32772
32773
32774
32775
32776
SMS OK. Message successfully delivered
to base station
Out of resources
Message too large for access channel
Message too large for dedicated channel
Network not ready
Phone not ready
Not allowed in AMPS
Cannot send broadcast
Possible Responses
OK
Note: Set default value of 0
OK
+WSRA: 1
OK
+WSRA: (0-1)
OK
Note: Test Command
Chapter 14 – Short Message Service Control Commands
78

Related parts for MTCBA-C1-N16