T5743P3-TGS Atmel, T5743P3-TGS Datasheet - Page 23

• Manufacturer Part Number: T5743P3-TGS
• Description: IC RCVR ASK/FSK 300MHZ 20-SOIC
• Manufacturer: Atmel

Specifications of T5743P3-TGS

• Frequency: 300MHz ~ 450MHz
• Sensitivity: -108dBm
• Data Rate - Maximum: 10 kBaud
• Modulation Or Protocol: ASK, FSK
• Applications: General Purpose Data Transmission Systems
• Current - Receiving: 30mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 20-SOIC (0.300", 7.50mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Features: -
• Memory Size: -

Figure 31. Controlled Noise Suppression
Configuration of the
Receiver
4569A–RKE–12/02
Serial bi-directional
data line
(DATA_CLK)
POLLING/_ON
Bit-check
mode
Bit check ok
Preburst
The T5743 receiver is configured via two 12-bit RAM registers called OPMODE and
LIMIT. The registers can be programmed by means of the bidirectional DATA port. If the
register contents have changed due to a voltage drop, this condition is indicated by a
certain output pattern called reset marker (RM). The receiver must be reprogrammed in
that case. After a power-on reset (POR), the registers are set to default mode. If the
receiver is operated in default mode, there is no need to program the registers. Table 4
shows the structure of the registers. According to Table 2 bit 1 defines if the receiver is
set back to polling mode via the OFF-command (see section “Receiving Mode”) or if it is
programmed. Bit 2 represents the register address. It selects the appropriate register to
be programmed. To get a high programming reliability, Bit15 (Stop bit), at the end of the
programming operation, must be set to 0.
Table 2. Effect of Bit 1 and Bit 2 on Programming the Registers
Table 3. Effect of Bit 15 on Programming the Register
Bit 1
Data
1
0
0
Receiving mode
Bit 15
0
1
Digital Noise
Bit 2
x
1
0
OFF-command
Action
The receiver is set back to polling mode (OFF command)
The OPMODE register is programmed
The LIMIT register is programmed
Action
The values will be written into the register (OPMODE or LIMIT)
The values will not be written into the register
Start-up
mode
Bit-check
mode
Bit check ok
Preburst
Receiving mode
Data
Digital Noise
Sleep
mode
T5743
23