MC33596FCAER2 Freescale Semiconductor, MC33596FCAER2 Datasheet - Page 62
![no-image](/images/manufacturer_photos/0/2/262/freescale_semiconductor_sml.jpg)
MC33596FCAER2
Manufacturer Part Number
MC33596FCAER2
Description
IC UHF RECEIVER PLL TUNED 32-QFN
Manufacturer
Freescale Semiconductor
Datasheet
1.MC33596FCAE.pdf
(70 pages)
Specifications of MC33596FCAER2
Frequency
304, 315, 426, 434, 868 & 915MHz
Sensitivity
-104dBm
Data Rate - Maximum
22.4 kBaud
Modulation Or Protocol
FSK, OOK
Applications
General Data Transfer
Current - Receiving
10.3mA
Data Interface
PCB, Surface Mount
Antenna Connector
PCB, Surface Mount
Voltage - Supply
2.7 V ~ 3.6 V, 4.5 V ~ 5.5 V
Operating Temperature
-20°C ~ 85°C
Package / Case
32-QFN
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Features
-
Memory Size
-
PCB Design Recommendations
21
Pay attention to the following points and recommendations when designing the layout of the PCB.
62
•
•
•
Ground Plane
— If you can afford a multilayer PCB, use an internal layer for the ground plane, route power
— Use at least a double-sided PCB.
— Use a large ground plane on the opposite layer.
— If the ground plane must be cut on the opposite layer for routing some signals, maintain
Power Supply, Ground Connection and Decoupling
— Connect each ground pin to the ground plane using a separate via for each signal; do not use
— Place each decoupling capacitor as close to the corresponding VCC pin as possible (no more
— Locate the VCCDIG2 decoupling capacitor (C10) directly between VCCDIG2 (pin 14) and
RF Tracks, Matching Network and Other Components
— Minimize any tracks used for routing RF signals.
— Locate crystal X1 and associated capacitors C6 and C7 close to the MC33596. Avoid loops
— Use high frequency coils with high Q values for the frequency of operation (minimum of 15).
PCB Design Recommendations
supply and digital signals on the last layer, with RF components on the first layer.
continuity with another ground plane on the opposite layer and a lot of via to minimize
parasitic inductance.
common vias.
than 2–3 mm away).
GND (pin 16).
occurring due to component size and tracks. Avoid routing digital signals in this area.
Validate any change of coil source.
The values indicated for the matching network have been computed and
tuned for the MC33596 RF Modules available for MC33596 evaluation.
Matching networks should be retuned if any change is made to the PCB
(track width, length or place, or PCB thickness, or component value). Never
use, as is, a matching network designed for another PCB.
MC33596 Data Sheet, Rev. 4
NOTE
Freescale Semiconductor