T5744N-TKQ Atmel, T5744N-TKQ Datasheet - Page 6

• Manufacturer Part Number: T5744N-TKQ
• Description: IC RCVR PLL ASK 450MHZ 20-SSOP
• Manufacturer: Atmel

Specifications of T5744N-TKQ

• Frequency: 300MHz ~ 450MHz
• Sensitivity: -108dBm
• Modulation Or Protocol: ASK
• Applications: General Purpose Data Transmission Systems
• Current - Receiving: 30mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 20-SSOP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Features: -
• Memory Size: -
• Data Rate - Maximum: -
• Other names: T5744N-TKQTR

Figure 6. Input Matching Network without SAW Filter
Analog Signal Processing
IF Amplifier
RSSI Amplifier
Pin RSSI
6
f
RF
RF
T5744
IN
= 433.92 MHz
C3
15p
3.3p
22n
TOKO LL2012
25n
100p
F22NJ
Please note that for all coupling conditions (see Figure 5 and Figure 6), the bond wire
inductivity of the LNA ground is compensated. C3 forms a series resonance circuit
together with the bond wire. L = 25 nH is a feed inductor to establish a DC path. Its value
is not critical but must be large enough not to detune the series resonance circuit. For
cost reduction, this inductor can be easily printed on the PCB. This configuration
improves the sensitivity of the receiver by about 1 dB to 2 dB.
The signals coming from the RF front end are filtered by the fully integrated 4th-order IF
filter. The IF center frequency is f
f
the center frequency.
The receiver T5744 employs an IF bandwidth of B
together with the U2741B in ASK mode.
The subsequent RSSI amplifier enhances the output signal of the IF amplifier before it is
fed into the demodulator. The dynamic range of this amplifier is DRRSSI = 60 dB. If the
RSSI amplifier is operated within its linear range, the best S/N ratio is maintained. If the
dynamic range is exceeded by the transmitter signal, the S/N ratio is defined by the ratio
of the maximum RSSI output voltage and the RSSI output voltage due to a disturber.
The dynamic range of the RSSI amplifier is exceeded if the RF input signal is about
60 dB higher compared to the RF input signal at full sensitivity.
The output voltage of the RSSI amplifier (VRSSI) is available at Pin RSSI. Using the
RSSI output signal, the signal strength of different transmitters can be distinguished.
The usable input power range P
Since different RF input networks may exhibit slightly different values for the LNA gain,
the sensitivity values given in the electrical characteristics refer to a specific input
matching. This matching is illustrated in Figure 6 and exhibits the best possible
sensitivity.
RF
8
9
= 433.92 MHz is used. For other RF input frequencies, refer to Table 1 to determine
LNAGND
LNA_IN
T5744
RF
IN
f
RF
Ref
= 315 MHz
IF
is -100 dBm to -55 dBm.
C3
33p
= 1 MHz for applications where f
3.3p
39n
TOKO LL2012
25n
100p
F39NJ
IF
8
9
= 600 kHz and can be used
LNAGND
LNA_IN
T5744
RF
= 315 MHz or
4521B–RKE–01/03