DC-WME-01T-S Digi International, DC-WME-01T-S Datasheet - Page 25

• Manufacturer Part Number: DC-WME-01T-S
• Description: WI-ME 8MB SDRAM 4MB FLASH SINGLE
• Manufacturer: Digi International
• Series: Digi Connect® Wi-MEr

Specifications of DC-WME-01T-S

• Frequency: 2.4GHz
• Data Rate - Maximum: 11Mbps
• Modulation Or Protocol: 802.11 b
• Applications: General Purpose
• Power - Output: 16dBm
• Sensitivity: -82dBm
• Voltage - Supply: 3.14 V ~ 3.45 V
• Data Interface: PCB, Through Hole
• Memory Size: 4MB Flash, 8MB RAM
• Antenna Connector: RP-SMA
• Operating Temperature: -30°C ~ 75°C
• Package / Case: Module
• Wireless Frequency: 2.4 GHz
• Interface Type: SMA
• Modulation: CCK, DBPSK, DQPSK
• Security: 64/128 WEP, WPA, 802.11i, TKIP
• Operating Voltage: 3.3 V
• Antenna: SMA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: NS7520
• Other names: 602-1037

Module JTAG Interface Connector, P8
JTAG Debugger Connector, P4
The Module JTAG Interface Connector is a 14-pin female vertical header that is labeled P8
on the development board. The connector mates with the JTAG connector on the Digi
Connect ME embedded module. The Module JTAG Connector pins are tied to the JTAG
debugger Connector (see “JTAG Debugger Connector, P4”).
Note
The JTAG debugger connector is a 14-pin male vertical header that is labeled P4 on the
development board. The connector mates with a JTAG debugger plug (for example, a
Macraigor Raven). The connector is used with the development kit only. See the following
figure for pin orientation. See the following table for pin assignments.
Note
Because there is no direct connection to the Module JTAG Interface Connector,
The figure shows the connector using the same orientation as shown in the
pin orientation and pin assignments are not described for the connector.
figure titled "Board Layout" on page 10.
17-19
Pin
13
14
15
16
20
Module Connector Pin Assignments
DCD / GPIO-1
RESET
+3.3V
GND
—
/INIT
Signal
Data Carrier Detect (Input) / GPIO
Reset
Power
Ground
Reserved. Do not connect.
Software Reset
Description
A b o u t t h e D e v e l o p m e n t B o a r d
1 7