TRC103 RFM, TRC103 Datasheet - Page 46

RFIC TRANSCEIVER MULTI-CHANNEL F

TRC103

Manufacturer Part Number
TRC103
Description
RFIC TRANSCEIVER MULTI-CHANNEL F
Manufacturer
RFM
Series
TRCr
Datasheet

Specifications of TRC103

Frequency
863MHz ~ 960MHz
Data Rate - Maximum
100kbps
Modulation Or Protocol
FSK, OOK
Applications
General Purpose
Power - Output
11dBm
Sensitivity
-112dBm
Voltage - Supply
2.1 V ~ 3.6 V
Current - Receiving
4mA
Current - Transmitting
30mA
Data Interface
PCB, Surface Mount
Antenna Connector
PCB, Surface Mount
Operating Temperature
-40°C ~ 85°C
Package / Case
32-QFN
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Memory Size
-
Other names
583-1095-2
J must be an integer value, so F
not an integer for your deviation and bit rate, round the value of J down to the nearest integer and use this value
to set the bandwidth of the receiver Butterworth filters for the bit rate you are using. For operation at 133 kb/s and
above, use a value of 15 for J.
The recommended 3 dB bandwidth for the receiver R-C filters is:
Where F
C filter bandwidth to the integer value in RXCFG10 bits 7..4 is given in Table 55. Where the calculated value for
F
R-C filter bandwidth.
6.2.2 Determining Transmitter Power Configuration Values
European ETSI EN 300 220-1 regulates unlicensed fixed-frequency and FHSS radio operation in the 863-
870 MHz band. A TRC103 transmitter power setting of 10 dBm can be used anywhere in this band, operating on
either fixed-frequency or FHSS. Refer to EN 300 220-1 for additional details.
FCC 15.247 and Canadian RSS-210 A8.1 regulate unlicensed FHSS radio operation in the 902-928 MHz band.
The TRC103’s maximum transmitter power setting of 11 dBm can be used under both regulations.
FCC 15.249 and Canadian RSS-210 A2.9 regulate fixed-frequency unlicensed radio operation in the 902-928
MHz band. Under 15.249, the allowed transmitter field strength measured at 10 ft is 50,000 µV/m. This level
equates to a transmitter power level of approximately 1 dBm for a 1/4 wave antenna of typical efficiency.
The relationship of the transmitter power level to the integer value in TXCFG1A bits 3..1 is given in Table 56.
There are six available power settings (approximate):
www.RFM.com
©2009-2010 by RF Monolithics, Inc.
CRC
falls between table values, use the higher table value. For operation at 100 kb/s and above, use the 987 kHz
F
CRC
CRC
and F
= 3.25*F
E-mail:
CBW
info@rfm.com
CBW
are in kHz. The bandwidth of F
CBW
is limited to 16 discrete values. If the value of J given in the above equation is
Pattern of Bits 7..4
Technical support +1.800.704.6079
0000
0001
0010
0011
0100
0101
0110
0111
1000
1001
1010
1011
1100
1101
1110
1111
Table 55
CRC
is set by bits 7..4 in RXCFG10. The relationship of the R-
R-C Filter Bandwidth
109 kHz
137 kHz
157 kHz
184 kHz
211 kHz
234 kHz
262 kHz
321 kHz
378 kHz
414 kHz
458 kHz
514 kHz
676 kHz
987 kHz
65 kHz
82 kHz
TRC103 - 12/15/10
Page 46 of 64

Related parts for TRC103