GS-BT2416C1.AT1 STMicroelectronics, GS-BT2416C1.AT1 Datasheet - Page 29

• Manufacturer Part Number: GS-BT2416C1.AT1
• Description: BLUETOOTH CLASS 1 SPP W/SOFTWARE
• Manufacturer: STMicroelectronics

Specifications of GS-BT2416C1.AT1

• Frequency: 2.4GHz
• Data Rate - Maximum: 721kbps
• Modulation Or Protocol: Bluetooth v2.1+EDR, class 1
• Applications: General Purpose
• Power - Output: 20dBm
• Sensitivity: -84dBm
• Voltage - Supply: 3.3V
• Current - Receiving: 60mA
• Current - Transmitting: 180mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -20°C ~ 70°C
• Package / Case: Module
• Processor Series: STLC2500
• Wireless Frequency: 2.4 GHz to 2.5 GHz
• Interface Type: SPI, I2C, UART, PCM
• Data Rate: 721 Kbps
• Modulation: USB, UART, PCM, SPI, IýC
• Output Power: 100 mW
• For Use With: 497-6224 - DEMO BOARD FOR GS-BT2416C2.ATI497-6223 - DEMO BOARD FOR GS-BT2416C2.H497-5792 - BOARD DEMO FOR CLASS 1 MODULES
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-5789

GS-BT2416C1.AT1
A.24
Note:
A.25
See AT+BTCONNECT
AT+BTDISCONNECT
Disconnect the current existing SPP Bluetooth
command returns an OK message and GPIO1 is set to low.
AT+ECHO
Enable or disable the output of events and functional messages by the module.
Syntax:
Parameters:
BdAddress: Bluetooth
6-byte hexadecimal value: i.e.
PortN: Port number of the remote SPP port. A value of “0” force the device to
query the remote device for a SPP service port and to get the first valid port; this
behavior is useful for programmed automatic recursive connect.
PinCode: 4 to 16-byte string representing the connection pin code
NRetry: number of possible attempts if the connection fail. A “0” set the device for
infinite attempts. Value range is 0 - 255.
TimeRetry: time interval between attempts in seconds. Value range is 0 - 65535
Return value: <OK, ERROR>
Syntax: AT+BTDISCONNECT
Return value: <OK, ERROR>
Syntax: AT+ECHO=<ON,OFF>
Parameters:
ON: The ECHO mode is enabled and every message or events by the module will
be outputted. (default)
OFF: The ECHO mode is disabled and no output will be generated.
Return value: <OK, ERROR>
AT+BTCONNECT=00230A01F0A5
AT+BTCONNECT=BdAddress,PortN,
®
address of the remote device. This value is specified as a
®
link. When the link has been closed, the
“PinCode”,NRetry, TimeRetry
AT command
29/38