XBP09-DPUIT-156 Digi International, XBP09-DPUIT-156 Datasheet - Page 39

• Manufacturer Part Number: XBP09-DPUIT-156
• Description: MODULE XBEE PRO W/U.FL
• Manufacturer: Digi International
• Series: XBEE-PRO™r

Specifications of XBP09-DPUIT-156

• Frequency: 902MHz ~ 928MHz
• Data Rate - Maximum: 156kbps
• Modulation Or Protocol: FHSS
• Applications: ISM
• Power - Output: 17dBm (50mW)
• Sensitivity: -100dBm
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Receiving: 80mA
• Current - Transmitting: 210mA
• Data Interface: PCB, Through Hole
• Antenna Connector: U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1168

I/O Commands
XBee‐PRO® 900 RF Modules
AT
Command
IC
IR
IF
CB
Name and Description
IO Digital Change Detection.
Set/Read the digital IO pins to monitor for changes in the IO state. IC works with the
individual pin configuration commands (D0-D9, P0-P2). If a pin is enabled as a digital
input/output, the IC command can be used to force an immediate IO sample
transmission when the DIO state changes. IC is a bitmask that can be used to enable or
disable edge detection on individual channels. Unused bits should be set to 0.
Bit (IO pin):
1 (DIO1)
2 (DIO2)
3 (DIO3)
4 (DIO4)
5 (DIO5)
6 (DIO6)
7 (DIO7)
8 (DIO8)
9 (DIO9)
10 (DIO10)
11 (DIO11)
12 (DIO12)
IO Sample Rate.
Set/Read the IO sample rate to enable periodic sampling. For periodic sampling to be
enabled, IR must be set to a non-zero value, and at least one module pin must have
analog or digital IO functionality enabled (see D0-D9, P0-P2 commands). The sample
rate is measured in milliseconds.
Sleep Sample Rate.
Set/read the number of sleep cycles that must elapse between periodic IO samples. This
allows IO samples to be taken only during some wake cycles. During those cycles IO
samples are taken at the rate specified by IR.
Commissioning Pushbutton.
This command can be used to simulate commissioning button presses in software. The
parameter value should be set to the number of button presses to be simulated. For
example, sending the ATCB1 command will execute the action associated with 1
commissioning button press.
0 (DIO0)
© 2009 Digi International, Inc.
Parameter Range
0-0xFFFF
0 - 0xFFFF (ms)
1-0xFF
0-4
Default
0
0
1
n/a
39