TORX147LF,T Toshiba, TORX147LF,T Datasheet - Page 4

• Manufacturer Part Number: TORX147LF,T
• Description: Fiber Optic Transmitters, Receivers, Transceivers TOSLINK RECEIVER 15Mbps Vcc=3.3V
• Manufacturer: Toshiba

Specifications of TORX147LF,T

• Function: Fiber optic receiving module for digital audio interface
• Operating Voltage: 3 V
• Transmission Distance: 5 m
• Product: Receiver
• Data Rate: 0.1 Mbps to 15 Mbps
• Pulse Width Distortion: 15 ns
• Maximum Output Current: 2 mA
• Operating Supply Voltage: - 0.5 V to + 4.5 V
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: - 20 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: Digital Audio Optical Interface
• Other names: TORX147L(F,T)

(6)
(7)
(8)
(9)
(10) Soldering condition
(11) The hole for chassis
(12) Case(receptacle) material
Panel attachment
TORX147L(F,T) has hole for panel attachment. Please be sure to attach it to panel with self−tapping
screw.
Solvent
Supply voltage
Use the supply voltage within the recommended operating condition (V
that supply voltage does not exceed the maximum rating value of 4.5 V, even for an instant.
Output
If the receiver output is at low and is connected to the power supply, or if the output is high and is
connected to GND, the internal IC may be destroyed.
Solder at 260°C or less for no more than ten seconds.
Please make a hole for inserting optical connector
the slash part in the following figure.
When using solvent for flux removal, do not use a high acid or high alkali solvent. Be careful not to
pour solvent in to the optical connector ports. If solvent is inadvertently poured in to them, clean it off
using cotton tips.
The case is made of polycarbonate. Polycarbonate is usually stable with acid, alcohol, and
aliphatic hydrocarbons however, with petrochemicals (such as benzene, toluene, and acetone),
alkali, aromatic hydrocarbons, or chloric hydrocarbons, polycarbonate becomes cracked, swollen,
or melted. Please take care when choosing a packaging material by referencing the table below.
〈Chemicals to avoid with polycarbonate〉
A
B
C
D
Little deterioration
But staining
Cracked crazed,
Melted
｛ ｝ ：used as solvent
Decomposed
or Swollen
PHENOMENON
・nitric acid(low concentration) , hydrogen peroxide, chlorine
・acetic acid(70% or more)
・gasoline
・methyl isobutyl ketone, ethyl acetate, butyl acetate
・methyl methacrylate, ethyl ether, MEK
・acetone, m-amino alcohol, carbon tetrachloride
・carbon disulfide, trichloroethylene, cresol
・thinners, oil of turpentine
・triethanolamine
・concentrated sulfuric acid
・benzene
・styrene, acrylonitrile, vinyl acetate
・ethylenediamine, diethylenediamine
・{chloroform, methyl chloride, tetrachloromethane, dioxane}
・ammonia water
・other alkali
{1,2-dichloroethane}
4
CHEMICALS
CC
= 2.7 to 3.6V). Make sure
TORX147L(F,T)
2005-06-20