Morph-IC-II FTDI, Morph-IC-II Datasheet - Page 25

• Manufacturer Part Number: Morph-IC-II
• Description: Interface Modules & Development Tools USB Hi-Speed Altera Cyclone-II FPGA Mod
• Manufacturer: FTDI

Specifications of Morph-IC-II

• Interface Type: Programmable
• Data Bus Width: Serial, 8 bit
• Operating Supply Voltage: 5 V
• Product: Interface Modules
• Features: Ultra Fast FPGA Configuration, JTAG Interface
• Core Architecture: Cyclone
• Core Sub-architecture: Cyclone II
• Kit Contents: Board
• Kit Features: FT2232HQ Dual, Hi-Speed USB UART/FIFO IC Used For USB
• For Use With/related Products: FT2232H, EP2C5F256C8N
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Appendix A – FT2232H EEPROM Configuration
The Morph-IC-II utilises an EEPROM which contains the USB configuration descriptors for the FT2232H.
When this module is plugged into a PC or a USB reset is performed, the PC will read these descriptors.
The default values stored into the EEPROM are defined in Table 5.
Parameter
USB Vendor ID (VID)
USB Product UD (PID)
Serial Number Enabled?
Serial Number
Pull down I/O Pins in USB
Suspend
Manufacturer Name
Product Description
Max Bus Power Current
Power Source
USB Version
Remote Wake Up
Load VCP Driver
The EEPROM on the Morph-IC-II can be re-programmed over USB using the utility program MPROG or
FT_PROG. Both can be downloaded from the www.ftdichip.com. MPROG Version 3.5 or later is required
for the FT2232H chip. Users who do not have their own USB Vendor ID but would like to use a unique
Product ID in their design can apply to FTDI for a free block of unique PIDs. Contact FTDI support for this
service.
Copyright © 2010 Future Technology Devices International Limited
Table 5 - Default Internal EEPROM Configuration
Value
0403h
6010h
Yes
See Note
Disabled
FTDI
Morph-IC-II
500mA
Bus Powered
0200
Disabled
Disabled
Notes
FTDI default VID (hex)
FTDI default PID (hex)
A unique serial number is generated and programmed into
the EEPROM during device final test.
I/O pins on the FT2232H are pulled high during USB
Suspend (PWREN# is high).
Hi-Speed USB
Remote Wake Up is disabled
The Morph-IC-II will only load the D2XX device driver. The
loading of VCP ports is suppressed.
24