LPC-E2468 Olimex Ltd., LPC-E2468 Datasheet - Page 10

• Manufacturer Part Number: LPC-E2468
• Description: MCU, MPU & DSP Development Tools DEV BRD FOR LPC2468 128MBFLASH 16MBSDRAM
• Manufacturer: Olimex Ltd.

Specifications of LPC-E2468

• Processor To Be Evaluated: LPC2468
• Interface Type: Ethernet, USB, I2C, JTAG, SPI, UART
• Dimensions: 90 mm x 60 mm
• Operating Supply Voltage: 3.3 V
• Silicon Manufacturer: NXP
• Core Architecture: ARM
• Core Sub-architecture: ARM7TDMI
• Silicon Core Number: LPC2xxx
• Silicon Family Name: LPC24xx
• Kit Contents: Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 1776321 52R3625

JUMPER DESCRIPTION:
VDD1-10 pins
pin of the
the VREF pin
If the jumper
controls the PHY.
the SD/MMC
open, disables
work
pin of the NAND flash
MCU.
Programming).
LCP2478. This jumper is used in combination with the RST_E jumper.
the Reset
software to program the LCP2478. This jumper is used in combination with the ISP_E
jumper.
through
3.3V_E
3.3VA_E
VREF_E
PHY_PD
WP_E
NF_WPE
ISP_E
RST_E
N_CE/CS1
This is used when you want external software to program the
of the MCU.
the
This jumper, when closed, supplies 3.3 V voltage to the
Default state is closed.
This jumper, when closed, supplies 3.3 V voltage to the VDDA
MCU.
Default state is closed.
This jumper, when closed, supplies 3.3 V reference voltage to
of the MCU.
Default state is closed.
This jumper controls the PHY signal of the Ethernet controller.
is pen the PHY is always enabled, if the pin is closed the MCU
Default state is open .
This jumper, when closed, inputs the Write protect signal from
card to the MCU.
Default state is closed .
This jumper, when closed, write-protects the flash and when
the write protection.
Default state is open .
When 1-2 is shorted, you could select the flash memory for
Default position is 1-2 shorted.
If you put this jumper, you enable the ISP (In-System
Default state is open.
If you put this jumper, you enable external software to control
signal to the processor. This is used when you want external
Default state is open.
Chip Select 1 signal. If 2-3 is shorted, the #CE
memory is connected to the N_CE pin of the