M1AFS-ADV-DEV-KIT-PWR Actel, M1AFS-ADV-DEV-KIT-PWR Datasheet - Page 8

• Manufacturer Part Number: M1AFS-ADV-DEV-KIT-PWR
• Description: MCU, MPU & DSP Development Tools Fusion Advanced Dev Kit w/ Power
• Manufacturer: Actel

Specifications of M1AFS-ADV-DEV-KIT-PWR

• Processor To Be Evaluated: M1AFS1500-FGG484
• Interface Type: Ethernet, USB, I2C, UART
• Operating Supply Voltage: 1.5 V to 5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Introduction
Board Description
8
The Fusion Advanced Development Kit board provides a low-cost board for the system management platform, using the
Fusion FPGA’s advanced features, such as mixed-signal analog and embedded processor.
The board also provides a mixed-signal power management (MPM) circuitry that can be used for sequencing and
management. You can use the MPM for power management as it is done in application-specific standard products
(ASSPs). The MPM tool enables you to configure each of the available voltage channels, without the need to explore
details of the FPGA part on the board.
The evaluation board supports a Cortex-M1 embedded processor on a Fusion device in the FGG484 package. To enable
embedded system management the evaluation board includes the following:
• Ethernet and USB-to-UART interface for communication with the Fusion FPGA
• SRAM, parallel flash, and SPI flash
• I2C interface, organic light-emitting diode (OLED)
• Temperature diode, potentiometer, and pulse-width modulation (PWM) circuit
• Mixed-signal header for several daughter boards to be attached for extended mixed-signal applications
The board includes a programming stick header so the LCPS can be attached to the board for programming.
Table 2
M1AFS1500-FGG484
PWM CIRCUIT
POT CIRCUIT
CURRENT SENSING
TEMP MONITOR DIODE
GATE DRIVER
OSC-50
OSC-32
PUSH-BUTTON RESET
LEDS
DIPSWITCH
PUSHSWITCH
I2C HEADER
OLED DISPLAY
INTERFACE CONNECTOR
RVI HEADER
ETHERNET
USB/UART
BATTERY (not populated)
describes the Fusion Advanced Development Kit board components.
Name
Table 2 · Fusion Advanced Development Kit Board Components
Actel Fusion mixed-signal FPGA
PWM circuit
Potentiometer connected to the analog pin of the Fusion device
Two circuits for 1.5 V and 3.3 V current monitoring
External temperature diode connected to the Fusion device
Two external p-channel MOSFET
50 MHz clock oscillator
32.768 KHz off-chip crystal oscillator
System reset with Schmitt trigger
12-RED (4 more in production boards)
8 signals
7 signals
3 ports for I2C interface
Organic LED display, 96×16 pixels
38-pin finger header
RealView interface header for M1 debugging
10/100 interface
USB/UART adapter chip and connector
On-board battery slot for charging
Fusion Advanced Development Kit User’s Guide
Description