LIS35DE STMicroelectronics, LIS35DE Datasheet - Page 15
![Board Mount Accelerometers MEMS MOTION SENSOR 3 AXIS 2G/8G SDO NAN](/photos/16/15/161596/lga-14_sml.jpg)
LIS35DE
Manufacturer Part Number
LIS35DE
Description
Board Mount Accelerometers MEMS MOTION SENSOR 3 AXIS 2G/8G SDO NAN
Manufacturer
STMicroelectronics
Datasheet
1.LIS35DE.pdf
(39 pages)
Specifications of LIS35DE
Sensing Axis
Triple
Acceleration
2 g, 8 g
Supply Voltage (max)
3.6 V
Supply Voltage (min)
2.16 V
Supply Current
0.3 mA
Maximum Operating Temperature
+ 85 C
Minimum Operating Temperature
- 40 C
Digital Output - Bus Interface
I2C, SPI
Shutdown
Yes
Sensitivity
18 mg/digit, 72 mg/digit
Package / Case
LGA-14
Output Type
Digital
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
LIS35DE
Manufacturer:
STM
Quantity:
5 531
Part Number:
LIS35DETR
Manufacturer:
ST
Quantity:
20 000
LIS35DE
3
3.1
3.2
3.3
Functionality
The LIS35DE is a ultracompact, low-power, digital output 3-axis linear accelerometer
packaged in a LGA package. The complete device includes a sensing element and an IC
interface able to take the information from the sensing element and to provide a signal to the
external world through an I
Sensing element
A proprietary process is used to create a surface micro-machined accelerometer. The
technology allows to carry out suspended silicon structures which are attached to the
substrate in a few points called anchors and are free to move in the direction of the sensed
acceleration. To be compatible with the traditional packaging techniques a cap is placed on
top of the sensing element to avoid blocking the moving parts during the moulding phase of
the plastic encapsulation.
When an acceleration is applied to the sensor the proof mass displaces from its nominal
position, causing an imbalance in the capacitive half-bridge. This imbalance is measured
using charge integration in response to a voltage pulse applied to the sense capacitor.
At steady state the nominal value of the capacitors are few pF and when an acceleration is
applied the maximum variation of the capacitive load is in fF range.
IC interface
The complete measurement chain is composed by a low-noise capacitive amplifier which
converts into an analog voltage the capacitive unbalancing of the MEMS sensor and by
analog-to-digital converters.
The acceleration data may be accessed through an I
device particularly suitable for direct interfacing with a microcontroller.
The LIS35DE features a Data-Ready signal (RDY) which indicates when a new set of
measured acceleration data is available thus simplifying data synchronization in the digital
system that uses the device.
The LIS35DE may also be configured to generate an inertial Wake-Up and Free-Fall
interrupt signal accordingly to a programmed acceleration event along the enabled axes.
Both Free-Fall and Wake-Up can be available simultaneously on two different pins.
Factory calibration
The IC interface is factory calibrated for sensitivity (So) and Zero-g level (Off).
The trimming values are stored inside the device by a non volatile memory. Any time the
device is turned on, the trimming parameters are downloaded into the registers to be used
during the normal operation. This allows the user to use the device without further
calibration.
2
C/SPI serial interface.
Doc ID 15594 Rev 1
2
C/SPI interface thus making the
Functionality
15/39