SDN4-24-100LP SOLA HEVI DUTY, SDN4-24-100LP Datasheet - Page 3

• Manufacturer Part Number: SDN4-24-100LP
• Description: Linear & Switching Power Supplies 100W 24-28VDC 4A
• Manufacturer: SOLA HEVI DUTY
• Type: Industrialr

Specifications of SDN4-24-100LP

• Power Supply Type: Switching
• Power Supply Output Type: Fixed
• No. Of Outputs: 1
• Output Voltage: 24V
• Output Current: 4A
• Power Rating: 92W
• Brand/series: SDN Series
• Configuration: Enclosed
• Mounting Type: DIN Rail
• Number Of Outputs: 1
• Operation: Switching
• Output: 24 VDC @ 3.8 A
• Power, Output: 92 W
• Primary Type: AC-DC
• Special Features: Parallelable, PFC
• Voltage, Input: 85 to 264/210 to 375 VAC/VDC
• Voltage, Output: 24 VDC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

SDN-P Specifications (Single Phase), 12 Vdc and 48 Vdc Output
108
1. Input current ratings are specified with low input, line conditions and worst case efficiency
2. Losses are heat dissipation in watts at full load, nominal line.
3. Ripple/ noise is stated as typical values when measured with a 20 MHz bandwidth
H x W x D (inches/mm)
Weight (lbs/kg)
Nominal Voltage
Nominal Current
-Inrush current max.
Efficiency
Power Factor Correction
Nominal Voltage
Tolerance
Ripple
Overvoltage Protection
Nominal Current
Holdup Time
Parallel Operation
Power Back Immunity
EMC:
Approvals
Temperature
Humidity
MTBF:
- Standard
Warranty
General Protection/Safety
Status Indicators (Visual)
Status Indicators (Relay)
Fusing
Mounting
Connections
Case
-Free Space
4
-AC Range
-DC Range
-Frequency
-Line Regulation
-Load Regulation
-Time & Temp. Drift
values. Input current at nominal input settings will be typically half these values.
scope and 50 Ohm resister.
-Current Limit
-Emissions
-Immunity
-Input
-Output
3
Description
2
(Losses
5
1
2
4
3
)
EN61000-6-3, EN61204-3, EN55022 Class B, EN61000-3-2, EN61000-3-3
EN61000-6-2, EN61204-3, EN55024, IEC61000-4-2, IEC61000-4-3, IEC61000-4-4, IEC61000-4-5, IEC61000-4-6,
IEC61000-4-8, IEC61000-4-11
UL508 Listed, cULus; UL 60950-1, cURus; CE (LVD 73/23 & 93/68/EEC), (EMC 89/336 & 93/68/EEC). EN61000-3-2;
UL 60079-15 pending (Class 1, Zone 2 hazardous location, Groups IIA, IIB, IIC w/ T3 temp. class up to 60°C Ambient.);
EN60079-15 (ATEX); SEMI F47 Sag Immunity, RoHS
Storage: -25 to +85
(Convection cooling, no forced air required). Operation up to 50% load permissible with sideways or front side up mounting orientation.
Protected against continuous short -circuit, continuous overload, continuous open circuit. Protection Class 1 (IEC536),
Degree of Protection IP20 (IEC 529) Safe low voltage: SELV (acc. EN60950)
Green LED on when V
Normally Open solid state relay - signal active when V
Internally fused
Outputs are capable of providing high currents for short periods of time for inductive load startup or switching. Fusing may be required if
Nominal O/P current rating cannot be tolerated. Continuous current overload allows for reliable fuse tripping.
Simple snap-on to DIN TS35/7.5 or TS35/15 rail system. Unit should handle normal shock and vibration of industrial use
and transportation without falling off the rail.
Input: Screw terminals, connector size range: 16-10 AWG (1.5-6mm
Output: Two terminals per output, connector size range: 16-10 AWG (1.5-6mm
Fully enclosed metal housing with fine ventilation grid to keep out small parts.
4.88 × 2.56 × 4.55 (124 x 65 × 116)
< 16 Vdc with auto-recovery
110% of nominal - Fold Forward (Current rises, voltage drops to maintain constant power during overload up to max peak current)
12 V (11.8-15.2 Vdc Adj.)
> 84% typ. (17.28 W)
SDN 9-12-100P
2.0 A / 1.5 A
9 A (108 W)
Typ. < 20 A
2.4 (1.05)
16 Vdc
o
C, Operation -10 to +60
out
contact Technical Services at [phone] with any questions.
> 75% (with ± 5% tolerance) of nominal output voltage
Power Supplies
< ±2 % overall (combination Line, load, time and temperature related changes)
Visit our website at www.solahd.com or
>20 ms (Full load, 100 Vac Input @ T
70 mm above and below, 25 mm left and right, 15mm in front
o
C full power; with linear derating to half power from 60 to 70
Supplies will not be damaged with parallel operation
< 90% RH, non-condensing; IEC 68-2-2, 68-2-3
out
Telcordia/Bellcore, Issue Case 3 @25
>70% of nominal output voltage (rated up to 200 mA, 60 Vdc)
Installation
General
Output
Input
< 60 Vdc with auto-recovery
48 V (35.8 - 52 Vdc Adj.)
115/230 Vac auto select
Units fulfill EN61000-3-2
> 88% typ. (28.8 W)
4. Unit shall not shutdown or ‘hiccup’ during overload or short circuit. Maximum current value
85-132/176-264 Vac
SDN 5-48-100P
47-63 Hz, 400 Hz
shown shall be maintained indefinitely without damage to the supply. Voltage shall drop
according to amount of overload to protect supply from damage.
Catalog Number
5 A (240 W)
4 A / 2.3 A
>500,000 hrs
2
210-375 Vdc
) for solid conductors.
< 50 mVpp
60 Vdc
< 0.5%
< 0.5%
5 years
< 1%
amb
2
=+25°C) to 95% output Voltage
) for solid conductors.
4.88 × 3.26 × 4.55 (124 × 83 × 116)
o
C
typ. < 40 A
3.3 (1.48)
o
C
< 16 Vdc with auto-recovery
12 V (11.6-14.0 Vdc Adj.)
> 84% typ. (30.72 W)
SDN 16-12-100P
16 A (192 W)
3.3 A / 1.7 A
16 Vdc
ATEX 05 21715U
DEMK0 06