SDN4-24-100LP SOLA HEVI DUTY, SDN4-24-100LP Datasheet - Page 4

no-image

SDN4-24-100LP

Manufacturer Part Number
SDN4-24-100LP
Description
Linear & Switching Power Supplies 100W 24-28VDC 4A
Manufacturer
SOLA HEVI DUTY
Type
Industrialr
Datasheets

Specifications of SDN4-24-100LP

Power Supply Type
Switching
Power Supply Output Type
Fixed
No. Of Outputs
1
Output Voltage
24V
Output Current
4A
Power Rating
92W
Brand/series
SDN Series
Configuration
Enclosed
Mounting Type
DIN Rail
Number Of Outputs
1
Operation
Switching
Output
24 VDC @ 3.8 A
Power, Output
92 W
Primary Type
AC-DC
Special Features
Parallelable, PFC
Voltage, Input
85 to 264/210 to 375 VAC/VDC
Voltage, Output
24 VDC
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
SDN-P Specifications (Three Phase)
1. For the SDN 20-24-480C, single phase input is permissible, but output is derated
2. Not UL listed for DC input.
3. Input current ratings are conservatively specified with low input, worst case
H x W x D (inches/mm)
Weight (lbs/kg)
Nominal Voltage
-AC Range
-DC Range
-Frequency
Nominal Current
-Inrush current max.
Efficiency (Losses
Power Factor
Correction
Nominal Voltage
-Tolerance
-Ripple
Overvoltage
Protection
Nominal Current
-Peak Current
-Current Limit
Holdup Time
Parallel Operation
EMC:
-Emissions
Approvals
Temperature
MTBF:
- Standard
Warranty
General Protection/
Safety
Status Indicators
Fusing
-Input
-Output
Mounting
Connections
Case
-Free Space
-Immunity
efficiency and power factor.
to 75% (15 Amps @ 24 Vdc).
Description
5
2
7
6
3
4
)
EN61000-6-3, -4; Class B EN55011, EN55022 Radiated and Conducted including Annex A.
EN61000-6-1, -2; EN61000-4-2 Level 4, EN61000-4-3 Level 3; EN61000-4-6 Level 3; EN61000-4-4
Level 4 input and Level 3 output; EN61000-4-5 Isolation Class 4, EN61000-4-11;
CB Scheme, EN60950; UL508 Listed, cULus; UL60950, cRUus, CE (LVD 73/23 & 93/68/EEC). EN61000-3-2, UL60079-15
Class 1, Zone 2 Hazardous Location, Groups IIA, IIB, IIC w/T3 temp class up to 60°C Ambient.
Storage: -25°C...+85°C Operation. -10°C -60°C full power with operation to 70°C possible with a linear derating to half power from 60°C to 70°C
(Convection cooling, no forced air required). Operation up to 50% load permissible with sideways or front side up mounting orientation. The relative
humidity is < 90% RH, noncondensing; IEC 68-2-2, 68-2-3.
Protected against continuous short-circuit, overload, open-circuit. Protection Class 1 (IEC536), degree of protection IP20 (IEC 60529) Safe low voltage:
SELV (acc. EN60950)
Green LED on when V
Internally fused
Outputs are capable of providing high currents for short periods of time for inductive load startup or switching. Fusing may be required for wire/loads
if 2x Nominal O/P current rating cannot be tolerated. Continuous current overload allows for reliable fuse tripping.
Simple snap-on system for DIN Rail TS35/7.5 or TS35/15 or chassis-mounted (optional screw mounting set SDN-PMBRK2 required).
Input: IP20-rated screw terminals, connector size range: 16-10 AWG (1.5-6 mm
Output: Two connectors per output, connector size range: 16-10 AWG (1.5-6 mm
Fully enclosed metal housing with fine ventilation grid to keep out small parts.
2x Nominal Current < 2 sec.
5A through 30A units may be passively paralleled by selecting the “P” position of the switch on the unit. The SDN 40 contains active current balancing.
> 1,110,000 hours
> 90% typ. (12 W)
25 mm above and below, 25 mm left and right,
4.88 x 2.91 x 4.55
SDN 5-24-480
(124 x 73 x 116)
5 A (120 W)
1.7 (.77)
0.5 A
6A,
1Ø or 3Ø 380-480 Vac
Fold Forward (Current rises, voltage drops to maintain constant power during overload up to max peak current)
out
15 mm in front
= 18V or greater.
contact Technical Services at (800) 377-4384 with any questions.
> 40 ms
2x Nominal Current < 2 sec.
SDN 10-24-480
< ±2% overall (combination Line, load, time and temperature related changes)
> 940,000 hours
4.88 x 3.5 x 4.55
(124 x 89 x 116)
10 A (240 W)
typ. < 18 A
Visit our website at www.solahd.com or
2.16 (.98)
0.8 A
12A,
> 90% typ. (48 W)
> 30 Vdc, but < 33 Vdc, auto recovery
Installation
General
Output
Input
24 Vdc (22.5 - 28.5 Vdc adj.)
Power Supplies
2x Nominal Current < 2 sec.
Units Fulfill EN61000-3-2
MIL STD 217F @ 30
4. Losses are heat dissipation in watts at full load, nominal input line.
5. Ripple/noise is stated as typical values when measured with a 20 MHz, bandwidth
6. Full load, 100 Vac Input @ T
7. For the SDN 40-24-480, output: one (+) two (-) connectors, size range 16-5 AWG
SDN 20-24-480C
Catalog Number
> 550,000 hours
(124 x 150 x 116)
4.88 x 5.9 x 4.55
380 - 480 Vac
450 - 820 Vdc
340 - 576 Vac
20 A (480 W)
scope and 50 Ohm resistor.
(1.5016 mm
< 50 mVpp
47 - 63 Hz
3.97 (1.8)
1Ø or 3Ø
> 28 ms
5 years
1.5 A
25A,
70 mm above and below, 25 mm left and right , 15 mm in front
2
) for solid conductors. 16-12 AWG (0.5-4 mm
2
2
) for solid conductors.
) solid conductor.
1
o
C
35A, 2x Nominal Current
amb
> 90% typ. (72 W)
SDN 30-24-480
> 620,000 hours
4.88 x 9.72 x 4.55
(124 x 247 x 116)
= +25°C
30 A (720 W)
< 2 sec.
4 (1.81)
2.0 A
3Ø 380 - 480 Vac
typ. < 30 A
> 20 ms
45A, 2x Nominal Current
2
) for flexible conductors.
> 90% typ. (96 W)
SDN 40-24-480
4.88 x 11.1 x 4.55
> 490,000 hours
(124 x 282 x 116)
40 A (960 W)
6.6 (2.99)
< 2 sec
3.0 A
4
109

Related parts for SDN4-24-100LP