PT7C4337WEX Pericom Semiconductor, PT7C4337WEX Datasheet - Page 3

• Manufacturer Part Number: PT7C4337WEX
• Description: IC REAL TIME CLK/CALENDAR 8-SOIC
• Manufacturer: Pericom Semiconductor
• Type: Clock/Calendar/Alarmr

Specifications of PT7C4337WEX

• Time Format: Binary
• Date Format: Binary
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (0.154", 3.90mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Other names: PT7C4337WEXTR

|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Function Block
Function Description
Overview of Functions
Clock function
CPU can read or write data including the year (last two digits), month, date, day, hour, minute, and second. Any (two-digit) year
that is a multiple of 4 is treated as a leap year and calculated automatically as such until the year 2100.
Alarm function
This device has two alarm system (Alarm 1 and Alarm 2) that outputs interrupt signals from INTA or INTB to CPU when the date,
day of the week, hour, minute or second correspond to the setting. Each of them may output interrupt signal separately at a
specified time. The alarm is be selectable between on and off for matching alarm or repeating alarm.
Programmable square wave output
A square wave output enable bit controls square wave output at pin 7. Frequencies are selectable: 1, 4.096k, 8.192k, 32.768k Hz.
Interface with CPU
Data is read and written via the I
Since the output of the I/O pin SDA is open drain, a pull-up resistor should be used on the circuit board if the CPU output I/O is
also open drain.
The SCL's maximum clock frequency is 400 kHz, which supports the I
Oscillator fail detect
When oscillator fail, PT7C4337 OSF bit will be set.
Oscillator enable/disable
Oscillator and time count chain can be enabled or disabled at the same time by /ETIME bit.
PT0205(08/09)
SQW/INTB
32.768
kHz
INTA
X2
X1
C
C
D
G
Control Register
OSC
2
Square Wave Output Control
C bus interface using two signal lines: SCL (clock) and SDA (data).
PT7C4337
Interrupt Control
Counter Chain
3
Decoder
Address
Comparator 1
Comparator 2
2
C bus's high-speed mode.
(Sec,Min,Hour,Day,Date,Month,Year)
Shift Register
Real-time Clock Module (I
Time Counter
Register
Address
(Sec, Min, Hour, Day/Date)
(Min, Hour, Day/Date)
Alarm 1 Register
Alarm 2 Register
Interface
(I
I /O
2
C)
Data Sheet
PT7C4337
2
C Bus)
SDA
SCL
Ver: 4