STM32W108B-SK STMicroelectronics, STM32W108B-SK Datasheet - Page 27

• Manufacturer Part Number: STM32W108B-SK
• Description: STARTER KIT FOR STM32W108
• Manufacturer: STMicroelectronics
• Series: STM32r
• Type: MCUr

Specifications of STM32W108B-SK

• Featured Product: STM32 Cortex-M3 Companion Products
• Contents: Board
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: Cortex - M3
• Silicon Core Number: STM32
• Silicon Family Name: STM32W108xx
• Kit Contents: Board
• Features: IEEE
• Mfg Application Notes: STM32W108 Adjacent Channel Rejection Measurements
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: *
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

UM0894
3.3
Note:
IAR Embedded Workbench® for ARM
To install the IAR Embedded Workbench® for ARM 5.40.7 or later, follow these steps:
1.
2.
3.
To build the binary image of all the available demonstration applications using the IAR tool,
follow these steps:
1.
2.
3.
To download the built binary image on the application board, follow these steps:
1.
2.
3.
4.
To use the J-Link Lite JTAG Flash programmer, you need to switch on the “power supply for
target” feature. The first time you plug the J-Link Lite on a PC USB port, follow these steps
(make sure that you have already installed the IAR Embedded Workbench 5.40.7 or later):
1.
2.
3.
Go to the Download section of the IAR website (www.iar.com) download section and
select a 30-day IAR version for ARM.
Start the download procedure and receive a 30-day license.
Insert the STM32W108 Starter Kit IAR CD-ROM (IAR 5.40.7) and follow the installation
instructions using the 30-day licence from the IAR website.
Open the IAR tool.
From the File > Open > Workspace menu, open the *.eww IAR project related to the
demonstration application you are going to address.
From the Project menu, select Rebuild All. A binary file is built under the project folder
specified in Project > Options > General Options Category > Output menu >
Executables/libraries item.
Connect the JTAG Flash programmer to the application board P4 connector and to a
PC USB port (through an USB cable).
Power the application board through the JTAG: P2 jumper fitted on 5-6 position.
From the Project menu, select Download and Debug. The binary image is downloaded
into the STM32W108xx Flash.
From the Project menu, select Stop Debugging. The application is ready to run.
Open an DOS Window on your PC.
Type jlink.
Issue the command: power on perm.
Doc ID 16999 Rev 4
STM32W108xx kits utilities and software tools
27/36