58628-2 Tyco Electronics, 58628-2 Datasheet - Page 4

• Manufacturer Part Number: 58628-2
• Description: PROCRMP DIESET 26-14 ULTRAFAST
• Manufacturer: Tyco Electronics
• Series: Pro-Crimper™ IIIr
• Type: Crimpersr

Specifications of 58628-2

• Rohs Compliant: NA
• Connector Type: Terminals and Splices
• Crimp Handle: A9996-ND
• Crimp Or Cable Size: 14-26 AWG
• Product: Crimping, Stripping & Cutting Tools & Drills
• Fits Cable/wire: 26-14 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: A9796

6. RATCHET (Crimp Height) ADJUSTMENT
7. MAINTENANCE AND INSPECTION
7.1. Maintenance
Ensure that the tool and dies are clean by wiping
them with a clean, soft cloth. Remove any debris with
a clean, soft brush. Do not use objects that could
damage the tool. When not in use, keep handles
closed to prevent objects from becoming lodged in
the crimping dies, and store in a clean, dry area.
7.2. Visual Inspection
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
4 of 4
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. With a screwdriver, adjust the ratchet wheel
from the front of the tool.
3. Observe the ratchet adjustment wheel. If a
tighter crimp is required, rotate the adjustment
wheel counterclockwise to a higher--numbered
setting. If a looser crimp is required, rotate the
adjustment wheel clockwise to a lower--numbered
setting.
4. Re--assemble the lockscrew.
5. Make a sample crimp and measure the crimp
height. If the dimension is acceptable, the
adjustment setting is correct. If the dimension is
unacceptable, continue to adjust the ratchet, and
again measure a sample crimp.
Ratchet
Adjustment
Wheel
Screwdriver
Lockscrew
Figure 5
(Figure 5)
Tyco Electronics Corporation
damaged. Inspect the crimping sections for flattened,
chipped, worn, or broken areas. If damage or
abnormal wear is evident, the tool must be replaced.
See Section 8, REPLACEMENT.
8. REPLACEMENT
Customer--replaceable parts are shown in Figure 1.
Available separately, PRO--CRIMPER III Hand
Crimping Tool Repair Kit 679221--1 includes a
replacement nut and a variety of pins, rings, screws,
and springs.
If the dies are damaged or worn excessively, they
must be replaced.
Order the repair kit and replaceable parts through
your Tyco Electronics representative, or call
1--800--526--5142, or send a facsimile of your
purchase order to 717--986--7605, or write to:
9. REVISION SUMMARY
Revisions to this instruction sheet include:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS
PO BOX 3608
HARRISBURG PA 17105--3608
S
S
S
PRO--CRIMPER II Hand Tool changed to
PRO--CRIMPER III Hand Tool;
Applied the TE logo; and
Updated format to the current corporate
requirements.
Rev A