102.1947 FISCHER CONNECTORS, 102.1947 Datasheet - Page 21
![SEALING CAP, MATING FACE OF RECEPTACLE](/photos/39/52/395264/4767243_sml.jpg)
102.1947
Manufacturer Part Number
102.1947
Description
SEALING CAP, MATING FACE OF RECEPTACLE
Manufacturer
FISCHER CONNECTORS
Datasheet
1.102.1947.pdf
(108 pages)
Specifications of 102.1947
Accessory Type
Sealing Cap
Rohs Compliant
Yes
For Use With
Mating Face Of The Receptacles
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
All dimensions shown are in millimeters and are for reference only.
HIGH VOLTAGE
D 105 A039
The mechanical specifications of high voltage connectors are listed separately in the three sections.
The electrical specifications are included with the standard connector types as:
G
G
G
Type «A» and «Z»
With high voltage connectors, it is essential to pay attention to the differences between type «A» and «Z» connectors.
Type «A»: The contacts of the receptacle are recessed to reduce the possibility of electric shock in the unmated position.
Type «A»:
Type «Z»: The contacts of the plug are recessed to reduce the possibility of electric shock in the unmated position.
Type «Z»:
Protected contacts are usually female contacts recessed in the insulator. In some high voltage connectors, however, it is
safer to recess the male contacts. In these cases, the plug type «A» is equipped with female contacts and the receptacle with
protected male contacts. This applies to the multipole HT connector series:
Example:
This also applies to the mixed HT connectors:
Example:
D 105 A036
Tamper-Proof Connectors SV/SVE
To avoid unauthorized or unintentional disengagement of connectors, we offer plugs with an integral safety locking ring.
When tightened, this knurled ring will prevent unmating of the plug. For an even greater level of safety, this ring can be
immobilized with a simple hex wrench. This feature is especially suited for applications involving high voltage or current.
For outside dimensions see pages B1 and C2.
Cable Clamp Sets
Coaxial high voltage connectors are supplied with standard metal clamps.
Most of the high voltage multipole and mixed contact connectors are fitted with insulating, one-piece clamps for optimal
high voltage ratings. The termination of a cable screen to the connector shell and/or sealing of the cable to the connector
shell is not possible with this clamp type. See «Insulating Cable Clamps» on page H8.
For terminating a shield or an anti-corona coating, metal collets for some cable diameters are available on request.
Insulating collets see on page H8.
Coaxial high voltage connectors under «Coax, Triax», section D
Multipole high voltage connectors under «Multipole», section E
Mixed high/low voltage connectors under «Mixed Contacts», section F
104 A062, 105 A039, 105 A057, 106 A013 and 107 A034
105 A020, 105 A036, 105 A060, 105 A127 and 106 A014
This version should be used when the voltage is sourced from the plug.
This version should be used when the voltage is sourced from the receptacle.
MECHANICAL SPECIFICATIONS
S 105 A039
S 105 A036
1
C