S29GL01GP11FFIR20 Spansion Inc., S29GL01GP11FFIR20 Datasheet - Page 21

• Manufacturer Part Number: S29GL01GP11FFIR20
• Description: Flash - NOR IC
• Manufacturer: Spansion Inc.

Specifications of S29GL01GP11FFIR20

• Memory Size: 1000Mbit
• Memory Configuration: 128K X 16
• Ic Interface Type: CFI, Parallel
• Access Time: 110ns
• Supply Voltage Range: 3V To 3.6V
• Memory Case Style: TSOP
• No. Of Pins: 64
• Cell Type: NOR
• Density: 1Gb
• Access Time (max): 110ns
• Interface Type: Parallel
• Boot Type: Not Required
• Address Bus: 27/26Bit
• Operating Supply Voltage (typ): 3/3.3V
• Operating Temp Range: -40C to 85C
• Package Type: Fortified BGA
• Sync/async: Asynchronous
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (min): 3V
• Operating Supply Voltage (max): 3.6V
• Word Size: 8/16Bit
• Number Of Words: 128M/64M
• Supply Current: 110mA
• Mounting: Surface Mount
• Pin Count: 64
• Lead Free Status / Rohs Status: Compliant

7.6
November 17, 2010 S29GL-P_00_A13
Autoselect
The Autoselect mode provides manufacturer ID, Device identification, and sector protection information,
through identifier codes output from the internal register (separate from the memory array) on DQ7-DQ0. This
mode is primarily intended for programming equipment to automatically match a device to be programmed
with its corresponding programming algorithm (see
in-system.
There are two methods to access autoselect codes. One uses the autoselect command, the other applies V
on address pin A9.
When using programming equipment, the autoselect mode requires V
Address pins must be as shown in
 To access Autoselect mode without using high voltage on A9, the host system must issue the Autoselect
 The Autoselect command sequence may be written to an address within a sector that is either in the read
 The Autoselect command may not be written while the device is actively programming or erasing.
 The system must write the reset command to return to the read mode (or erase-suspend-read mode if the
 It is recommended that A9 apply V
 See
 When verifying sector protection, the sector address must appear on the appropriate highest order address
command.
or erase-suspend-read mode.
sector was previously in Erase Suspend).
that A9 apply from V
bits (see
been set as required, the programming equipment may then read the corresponding identifier code on
DQ15-DQ0. The Autoselect codes can also be accessed in-system through the command register.
Table 12.1 on page 69
Table 7.4
to
ID
Table
D a t a
to V
S29GL-P MirrorBit
IH
for command sequence details.
7.5). The remaining address bits are don't care. When all necessary bits have
/V
IL
Table
S h e e t
before power-down the V
ID
after power-up sequence is completed. In addition, it is recommended
7.2.
®
Flash Family
Table
7.3). The Autoselect codes can also be accessed
CC
/V
IO
.
ID
(11.5 V to 12.5 V) on address pin A9.
21
ID