CS4373A-ISZ Cirrus Logic Inc, CS4373A-ISZ Datasheet - Page 29

• Manufacturer Part Number: CS4373A-ISZ
• Description: IC,D/A CONVERTER,SINGLE,24-BIT,SSOP,28PIN
• Manufacturer: Cirrus Logic Inc

Specifications of CS4373A-ISZ

• Rohs Compliant: YES
• Number Of Bits: 24
• Number Of Converters: 1
• Voltage Supply Source: Analog and Digital, Dual ±
• Power Dissipation (max): 10mW
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 28-SSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1778 - EVALUATION BOARD FOR CS5376
• Data Interface: -
• Settling Time: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 598-1646

rejected
Power Supply Characteristics
9.4 SCR Latch-up
The VA- pin is tied to the CS4373A CMOS
substrate and must always be the most-nega-
tive voltage applied to the device to ensure
SCR latch-up does not occur. In general,
latch-up may occur when any pin voltage ex-
ceeds
Absolute Maximum Ratings
It is recommended to connect the VA- power
supply to system ground (GND) with a re-
verse-biased Schottky diode. At power up, if
the VA+ power supply ramps before the VA-
supply is established, the VA- pin voltage
could be pulled above ground potential
through the CS4373A device. If the VA- supply
is pulled 0.7 V or more above GND, SCR
latch-up can occur. A reverse-biased Schottky
diode will clamp the VA- voltage a maximum of
0.3 V above ground to ensure SCR latch-up
does not occur at power up.
9.5 DC-DC Converters
Many low-frequency measurement systems
DS699F2
the
as
specified
limits
table.
table.
of
in
the
the
are battery powered and utilize DC-DC con-
verters to efficiently generate power supply
voltages. To minimize interference effects, op-
erate the DC-DC converter at a frequency
which is rejected by the digital filter, or operate
it synchronous to the MCLK rate.
A synchronous DC-DC converter whose oper-
ating frequency is derived from MCLK will the-
oretically minimize the potential for “beat
frequencies” to appear in the measurement
bandwidth. However this requires the source
clock to remain jitter-free within the DC-DC
converter circuitry. If clock jitter can occur with-
in the DC-DC converter (as in a PLL-based ar-
chitecture),
synchronous DC-DC converter whose switch-
ing frequency is rejected by the digital filter.
During PCB layout, do not place high-current
DC-DC converters near sensitive analog com-
ponents. Carefully routing a separate DC-DC
“star” ground will help isolate noisy switching
currents away from the sensitive analog com-
ponents.
it’s
better
to
use
CS4373A
a
non-
29