HCTL-2021-A00 Avago Technologies US Inc., HCTL-2021-A00 Datasheet - Page 11

• Manufacturer Part Number: HCTL-2021-A00
• Description: IC,Servo Encoder,CMOS,DIP,20PIN,PLASTIC
• Manufacturer: Avago Technologies US Inc.

Specifications of HCTL-2021-A00

• Applications: Encoder to Microprocessor
• Interface: 8-Bit Tristate
• Voltage - Supply: 4.5 V ~ 5.5 V
• Package / Case: 20-DIP (0.300", 7.62mm)
• Mounting Type: Through Hole
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 516-1883-5; HCTL-2021-A00

Position Data Latch
The position data latch is a 16-bit latch which captures
the position counter output data on each rising clock
edge, except when its inputs are disabled by the inhibit
logic section during two-byte read operations. The
output data is passed to the bus interface section.
When active, a signal from the inhibit logic section
prevents new data from being captured by the latch,
keeping the data stable while successive reads are
made through the bus section. The latch is
automatically re-enabled at the end of these reads. The
latch is cleared to 0 asynchronously by the RST signal.
Inhibit Logic
The Inhibit Logic Section samples the OE and SEL
signals on the falling edge of the clock and, in response
to certain conditions (see Figure 10), inhibits the
position data latch. The RST signal asynchronously
clears the inhibit logic, enabling the latch.
Bus Interface
The bus interface section consists of a 16 to 8 line
multiplexer and an 8-bit, three-state output buffer. The
multiplexer allows independent access to the low and
high bytes of the position data latch. The SEL and OE
signals determine which byte is output and whether
or not the output bus is in the high-Z state.
Figure 11. Simplified Inhibit Logic
11
Figure 10. Two Bytes Read Sequence
Step
1
2
3
L
H
SEL
X
OE
L
L
H
Falling
Falling
Falling
CLK
1
1
Inhibit Signal
0
Set inhibit; read high byte
Read low byte; starts reset
Complete inhibit logic reset
Action
Quadrature Decoder Output
The quadrature decoder output section consists of
count and up/down outputs derived from the 4x
decoder mode of the HCTL-2021-A00/PLC. When the
decoder has detected a count, a pulse, one-half clock
cycle long, will be output on the CNT
output will occur during the clock cycle in which the
internal counter is updated. The U/D pin will be set to
the proper voltage level one clock cycle before the
rising edge of the CNT
cycle after the rising edge of the CNT
outputs are not affected by the inhibit logic.
Cascade Output (HCTL-2021-A00/PLC only!)
The cascade output also consists of count and up/down
outputs. When the HCTL-2021-A00/PLC internal
counter overflows or underflows, a pulse, one-half clock
cycle long, will be output on the CNT
output will occur during the clock cycle in which the
internal counter is updated. The U/D pin will be set to
the proper voltage level one clock cycle before the
rising edge of the CNT
cycle after the rising edge of the CNT
outputs are not affected by the inhibit logic.
DCDR
CAS
pulse, and held one clock
pulse, and held one clock
DCDR
CAS
DCDR
CAS
pulse. These
pulse. These
pin. This
pin. This