PIC18F2320-E/SO Microchip Technology, PIC18F2320-E/SO Datasheet

no-image

PIC18F2320-E/SO

Manufacturer Part Number
PIC18F2320-E/SO
Description
IC,MICROCONTROLLER,8-BIT,PIC CPU,CMOS,SOP,28PIN,PLASTIC
Manufacturer
Microchip Technology
Series
PIC® 18Fr

Specifications of PIC18F2320-E/SO

Rohs Compliant
YES
Core Processor
PIC
Core Size
8-Bit
Speed
40MHz
Connectivity
I²C, SPI, UART/USART
Peripherals
Brown-out Detect/Reset, LVD, POR, PWM, WDT
Number Of I /o
25
Program Memory Size
8KB (4K x 16)
Program Memory Type
FLASH
Eeprom Size
256 x 8
Ram Size
512 x 8
Voltage - Supply (vcc/vdd)
4.2 V ~ 5.5 V
Data Converters
A/D 10x10b
Oscillator Type
Internal
Operating Temperature
-40°C ~ 125°C
Package / Case
28-SOIC (7.5mm Width)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Clarifications/Corrections to the Data
Sheet:
In the Device Data Sheet (DS39599G), the following
clarifications and corrections should be noted. Any sili-
con issues related to the PIC18F2220/2320/4220/4320
will be reported in a separate silicon errata. Please
check the Microchip web site for any existing issues.
1. Module: Power-Managed Modes
• In the third paragraph of Section 3.3.3 “RC_IDLE
• In the sixth paragraph of Section 3.4.3 “RC_RUN
© 2008 Microchip Technology Inc.
Mode” on page 35, the IOFS bit set time is
changed. The modified value is indicated in bold
text:
Mode” on page 37, the INTOSC clock source
stabilizing time has changed. The modified value
is indicated in bold text in the following excerpt of
the section:
If the IRCF bits are set to a non-zero value (thus
enabling the INTOSC output), the IOFS bit becomes
set after the INTOSC output becomes stable, in
about 128 μs.
If the IRCF bits are changed from all clear (thus
enabling the INTOSC output), the IOFS bit becomes
set after the INTOSC output becomes stable. Clocks
to the system continue while the INTOSC source
stabilizes in approximately 128 μs.
PIC18F2220/2320/4220/4320 Data Sheet Errata
PIC18F2220/2320/4220/4320
2. Module: Oscillator Configurations
• The first, third, fourth and fifth paragraphs of
Section 2.6.2 “OSCTUNE Register” on page 23
have been modified:
- First paragraph:
- Third paragraph:
- Fourth paragraph:
- Fifth paragraph:
The internal oscillator block is calibrated at the
factory to produce an INTOSC output frequency of
approximately 8 MHz. (See parameters F14
through F19 in Table 26-8).
The tuning sensitivity is constant throughout
the tuning range. This sentence is deleted.
OSCTUNE register does not affect the INTRC
frequency. The modified value is indicated in bold
text.
When the OSCTUNE register is modified, the
INTOSC frequency begins shifting to the new
frequency. The INTOSC clock will stabilize at
the new frequency within 100 µs. Code
execution continues during this shift.
Except for the first sentence (There is no
indication when the shift occurs), the remaining
content is deleted.
(INTRC)
DS80334B-page 1

Related parts for PIC18F2320-E/SO

PIC18F2320-E/SO Summary of contents

Page 1

... INTOSC output), the IOFS bit becomes set after the INTOSC output becomes stable. Clocks to the system continue while the INTOSC source stabilizes in approximately 128 μs. © 2008 Microchip Technology Inc. 2. Module: Oscillator Configurations (INTRC) • The first, third, fourth and fifth paragraphs of Section 2.6.2 “ ...

Page 2

... Minimum frequency bit 0 TUN<0>: This bit is a placeholder and has no effect on the INTOSC frequency. DS80334B-page 2 R/W-0 R/W-0 R/W-0 TUN4 TUN3 TUN2 U = Unimplemented bit, read as ‘0’ ‘0’ = Bit is cleared R/W-0 R/W-0 TUN1 TUN0 bit Bit is unknown © 2008 Microchip Technology Inc. ...

Page 3

... Center frequency. Oscillator module is running at the calibrated frequency 111111 • • 100000 = Minimum frequency bit 0 TUN<0>: Placeholder. This bit has no effect on the INTRC frequency. © 2008 Microchip Technology Inc. PIC18F2220/2320/4220/4320 R/W-0 R/W-0 R/W-0 TUN4 TUN3 TUN2 U = Unimplemented bit, read as ‘0’ ...

Page 4

... The current through the resistor can be estimated EXT (mA) with R in kΩ. EXT ≤ +85°C for Industrial ≤ +85°C for industrial ≤ +125°C for extended Conditions and all features that add delta © 2008 Microchip Technology Inc. ...

Page 5

... DD EXT 4: Standard low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature crystals are available at a much higher cost. © 2008 Microchip Technology Inc. PIC18F2220/2320/4220/4320 Standard Operating Conditions: (unless otherwise stated) -40°C ≤ T Operating temperature A Standard Operating Conditions: (unless otherwise stated) -40° ...

Page 6

... Features of the CPU). Rev B Document (6/2008) Removed previous Data Sheet Clarifications 1-6. Added new Data Sheet Clarifications 1 (Power-Managed Modes), 2 (Oscillator Configurations – INTRC), 3 (OSCTUN2 Register) and 4 (Electrical Characteristics – DC Power-Down and Supply Current). DS80334B-page 6 (I/O Ports), © 2008 Microchip Technology Inc. ...

Page 7

... PowerMate, PowerTool, REAL ICE, rfLAB, Select Mode, Total Endurance, UNI/O, WiperLock and ZENA are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. All other trademarks mentioned herein are property of their respective companies. ...

Page 8

... Philippines - Manila Tel: 63-2-634-9065 Fax: 63-2-634-9069 Singapore Tel: 65-6334-8870 Fax: 65-6334-8850 Taiwan - Hsin Chu Tel: 886-3-572-9526 Fax: 886-3-572-6459 Taiwan - Kaohsiung Tel: 886-7-536-4818 Fax: 886-7-536-4803 Taiwan - Taipei Tel: 886-2-2500-6610 Fax: 886-2-2508-0102 Thailand - Bangkok Tel: 66-2-694-1351 Fax: 66-2-694-1350 © 2008 Microchip Technology Inc. 01/02/08 ...

Related keywords