S29GL032A10TFIR40 Spansion Inc., S29GL032A10TFIR40 Datasheet - Page 39

• Manufacturer Part Number: S29GL032A10TFIR40
• Description: Flash - NOR IC
• Manufacturer: Spansion Inc.

Specifications of S29GL032A10TFIR40

• Memory Size: 32Mbit
• Memory Configuration: 64K X 8
• Ic Interface Type: Parallel
• Access Time: 100ns
• Memory Case Style: TSOP
• No. Of Pins: 48
• Operating Temperature Range: -40°C To +85°C
• Page/burst Read Access: 25ns

January 28, 2005 S29GLxxxA_00_A2
Write Protect (WP#)
Hardware Data Protection
Once the Secured Silicon Sector is programmed, locked and verified, the system
must write the Exit Secured Silicon Sector Region command sequence to return
to reading and writing within the remainder of the array.
Factory Locked: Secured Silicon Sector Programmed and
Protected At the Factory
In devices with an ESN, the Secured Silicon Sector is protected when the device
is shipped from the factory. The Secured Silicon Sector cannot be modified in any
way. An ESN Factory Locked device has an 16-byte random ESN at addresses
000000h–000007h. Please contact your sales representative for details on order-
ing ESN Factory Locked devices.
Customers may opt to have their code programmed by the factory through the
Spansion programming service (Customer Factory Locked). The devices are then
shipped from the factory with the Secured Silicon Sector permanently locked.
Contact your sales representative for details on using the Spansion programming
service.
The Write Protect function provides a hardware method of protecting the first or
last sector group without using V
by the WP#/ACC input.
If the system asserts V
erase functions in the first or last sector group independently of whether those
sector groups were protected or unprotected. Note that if WP#/ACC is at V
when the device is in the standby mode, the maximum input load current is in-
creased. See the table in
If the system asserts V
whether the first or last sector was previously set to be protected or un-
protected using the method described in “Sector Group Protection and
Unprotection”. Note that WP# has an internal pullup; when uncon-
nected, WP# is at V
The command sequence requirement of unlock cycles for programming or erasing
provides data protection against inadvertent writes (refer to
26
measures prevent accidental erasure or programming, which might otherwise be
caused by spurious system level signals during V
transitions, or from system noise.
Low V
When V
tects data during V
internal program/erase circuits are disabled, and the device resets to the read
Figure
tem protection of the Secured Silicon Sector without raising any device pin to
a high voltage. Note that this method is only applicable to the Secured Silicon
Sector.
Write the three-cycle Enter Secured Silicon Sector Region command se-
quence, and then use the alternate method of sector protection described in
the “Sector Group Protection and Unprotection” section.
for command definitions). In addition, the following hardware data protection
CC
CC
2, except that RESET# may be at either V
is less than V
A d v a n c e
Write Inhibit
CC
IH
power-up and power-down. The command register and all
IL
LKO
S29GLxxxA MirrorBit™ Flash Family
.
on the WP#/ACC pin, the device disables program and
“DC Characteristics” section on page
, the device does not accept any write cycles. This pro-
IH
I n f o r m a t i o n
on the WP#/ACC pin, the device reverts to
ID
. Write Protect is one of two functions provided
CC
IH
power-up and power-down
or V
ID
. This allows in-sys-
Table 25
65.
and
Table
IL
37