SMB55F BANNER ENGINEERING, SMB55F Datasheet - Page 3

• Manufacturer Part Number: SMB55F
• Description: Sensor Mounting Bracket
• Manufacturer: BANNER ENGINEERING

Specifications of SMB55F

• For Use With: R58E Series Expert Register Mark Sensors

Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: [phone]
The R58E is pre-set to power up in RUN mode and sense the most recently taught registration
mark. The sensitivity of the R58E may be quickly optimized by using one of two available
TEACH modes: Static TEACH or Dynamic TEACH.
• S tatic TEACH: Both the Output ON and Output OFF conditions are presented, and
• D ynamic TEACH: The registration mark is presented during actual sensing conditions, and
Remote TEACH
The sensor may be configured either via its push buttons, or via a remote switch. Remote
configuration also may be used to enter SETUP mode to set ON- and OFF-delay, and to
disable the push buttons to prevent unauthorized adjustment of the configuration settings.
To access this feature, connect the gray wire of the sensor to 0V dc, with a remote switch
between the sensor and 0V dc.
Configuration is accomplished by following the sequence of input pulses (see following
procedures). The duration of each pulse (corresponding to a push button “click”), and the
period between multiple pulses, are defined as “T”:
Status Indicators
Power
Output
Light Operate
Dark Operate
OFF-Delay
ON-Delay
8-Segment Bargraph
Display
sensitivity can be adjusted manually via the push buttons.
the sensitivity can be adjusted manually via the push buttons.
R58 Expert
LED
ON Green: RUN mode
OFF: TEACH or SETUP mode
ON Yellow: Output is conducting, or TEACH Output ON condition
OFF: Output is not conducting, or TEACH Output OFF condition
ON Green: Light Operate (LO) operation
ON Green: Dark Operate (DO) operation
ON Green: 30 ms pulse stretcher (OFF-delay) is active
OFF: No OFF-delay
ON Green: 30 ms ON-delay is active
OFF: No ON-delay
ON Red: RUN mode — Indicates signal strength with respect to the
OFF: TEACH or SETUP mode — Sensor configuration active
0.04 seconds ≤ “T” ≤ 0.8 seconds
™
Sensor Configuration
sensing threshold (switchpoint); higher segment number for
higher sensing contrast
TEACH mode — Indicates relative contrast
SETUP mode — Displays sensing beam LED color (see
Figure 5)
Registration Mark Sensors
Indicates
P/N 122928 rev. C
3