SMB55F BANNER ENGINEERING, SMB55F Datasheet - Page 6
![Sensor Mounting Bracket](/photos/19/84/198411/4253848_sml.jpg)
SMB55F
Manufacturer Part Number
SMB55F
Description
Sensor Mounting Bracket
Manufacturer
BANNER ENGINEERING
Datasheet
1.SMB55RA.pdf
(12 pages)
Specifications of SMB55F
For Use With
R58E Series Expert Register Mark Sensors
Figure 4. Output response configuration options
Figure 5. LED color configuration options
6
R58 Expert
SETUP mode is used to configure discrete sensor output response for:
• Light or Dark Operate
• 30-millisecond pulse stretcher (OFF-delay), if required
• 30-millisecond ON-delay, if required.
It is also used to disable one or more sensing beam colors, to force the sensor to use a
particular color. It will be necessary to access SETUP mode only if the settings which result
from TEACH mode configuration are not the settings required for the application or if a delay
is required. The status LEDs indicate the output response configuration when the sensor is in
RUN mode, as shown in Figure 4.
Change the output response settings or disable sensing beam color(s) as shown in the table
on page 7.
NOTE: I f SETUP mode programming is interrupted and remains inactive for 60 seconds,
No delay
All Colors
LO
P/N 122928 rev. C
the sensor returns to RUN mode with the most recent settings (i.e., exits and saves
current selection).
Double-Pulse or
Static Push Button
Double-Pulse or
Static Push Button
No delay
DO
Increment or decrement through the 8 possible setting combinations
Increment or decrement through the 7 possible setting combinations
Red
™
OFF-delay
LO
Registration Mark Sensors
Green
OFF-delay
SETUP Mode
DO
Blue
ON-delay
LO
Red and
Green
ON-delay
DO
Dynamic Push Button
Dynamic Push Button
Single-Pulse or
Single-Pulse or
Red and
OFF-delay
Blue
ON-delay
LO
Green and
OFF-delay
ON-delay
Blue
DO
Banner Engineering Corp. • Minneapolis, MN U.S.A
www.bannerengineering.com • Tel: 763.544.3164