SM91EANQD BANNER ENGINEERING, SM91EANQD Datasheet - Page 6

• Manufacturer Part Number: SM91EANQD
• Description: Photoelectric Sensor
• Manufacturer: BANNER ENGINEERING

Specifications of SM91EANQD

• Output Current: 150mA
• Sensor Output: NPN/PNP
• Supply Voltage Range Dc: 10V To 30V
• Peak Reflow Compatible (260 C): No
• Sensor Input: Optical
• Sensing Range Max: 30m
• Leaded Process Compatible: No

332
VALU-BEAM
Supply Voltage and Current
Output Configuration
Output Rating
Output Protection Circuitry
Output Response Time
Repeatability
Adjustments
Indicators
Construction
Environmental Rating
Connections
Operating Conditions
Certifications
Supply Protection Circuitry
®
912 Series Sensors
10 to 30V dc at 20 mA maximum, exclusive of load (except for SMA91E, ESR and EF emitters, which
operate from 10 to 250V ac or dc, 10 mA max.)
Protected against reverse polarity and transient voltages
Bipolar: One current sourcing (PNP) and one current sinking (NPN) open-collector transistor
250 mA continuous, each output
Off-state leakage current less than 10 microamps
Output saturation voltage (PNP output) less than 1 volt at 10 mA and less than 2 volts at 250 mA
Output saturation voltage (NPN output) less than 200 millivolts at 10mA and less than 1 volt at 250 mA
Protected against false pulse on power-up and continuous overload or short-circuit of outputs
4 milliseconds ON/OFF (except receiver-only units which are 8 milliseconds ON and 4 milliseconds OFF);
independent of signal strength
(NOTE: 100 millisecond delay on power-up; outputs non-conducting during this time)
Opposed and Glass Fiber Optic Emitter-Receiver pairs: 1.0 millisecond; Retro, Diffuse, Convergent and
Glass Fiber Optic: 1.3 milliseconds
LIGHT/DARK OPERATE select switch and SENSITIVITY control potentiometer, both located at rear of sensor
Exclusive, patented Alignment Indicating Device (AID
LED indicator whenever the sensor sees a “light” condition, with a superimposed pulse rate proportional
to the light signal strength (the stronger the signal, the faster the pulse rate). Models SMA91E &
SM91ESR emitter have a visible-red “tracer beam” which indicates “power on” and enables easy “line-of-
sight” alignment.
Reinforced thermoplastic polyester housing, totally encapsulated, molded acrylic lenses and stainless
steel hardware
Meets NEMA standards 1, 2, 3, 3S, 4, 4X, 12 and 13; IEC IP66
PVC-jacketed 2 m (6.5') or 9 m (30') cables or 4-pin mini-style quick-disconnect (QD) fitting available.
Note: Opposed mode emitters use 3-pin mini-style QD fitting. See page 368 and the Accessories section.
Temperature:
Maximum relative humidity: 90% at 50°C (non-condensing)
Banner Engineering Corp. • Minneapolis, U.S.A. • www.bannerengineering.com • Tel: [phone]
912 Series DC Specifications
-20° to +70° C (-4° to +158°F)
™
, US patent #4356393) lights a top mounted red