HFBR-4515 Avago Technologies US Inc., HFBR-4515 Datasheet - Page 6
HFBR-4515
Manufacturer Part Number
HFBR-4515
Description
FIBER OPTIC ADAPTOR SIMPLEX BLUE
Manufacturer
Avago Technologies US Inc.
Datasheet
1.HFBR-4515.pdf
(10 pages)
Specifications of HFBR-4515
Convert From (adapter End)
POF Simplex Receptacle
Convert To (adapter End)
POF Simplex Receptacle
Mounting Type
Panel Mount, Bulkhead
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Features
-
Mode
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
516-1891
HFBR-4515
Q2114296B
HFBR-4515
Q2114296B
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
HFBR-4515Z
Manufacturer:
AVAGO
Quantity:
1 400
Part Number:
HFBR-4515Z
Manufacturer:
AVAGO/安华高
Quantity:
20 000
Step 3
Any excess fiber protruding from the connector end may
be cut off; however, the trimmed fiber should extend at
least 1.5 mm (0.06 in) from the connector end.
Insert the connector fully into the polishing fixture with
the trimmed fiber protruding from the bottom of the
fixture. This plastic polishing fixture can be used to polish
two simplex connectors or simplex latching connectors
simultaneously, or one duplex connector.
Note: The four dots on the bottom of the polishing fixture
are wear indicators. Replace the polishing fixture when any
dot is no longer visible. Typically, the polishing fixture can
be used 10 times; 10 duplex connectors or 20 simplex con
nectors, two at a time.
Place the 600 grit abrasive paper on a flat smooth surface,
pressing down on the connector, polish the fiber and the
connector using a figure eight pattern of strokes until the
connector is flush with the bottom of the polishing fixture.
Wipe the connector and fixture with a clean cloth or tissue.
6
Step 4
Place the flush connector and polishing fixture on the dull
side of the 3 µm pink lapping film and continue to polish
the fiber and connector for approximately 25 strokes. The
fiber end should be flat, smooth and clean.
This cable is now ready for use.
Note: Use of the pink lapping film fine polishing step results in
approximately 2 dB improvement in coupling performance
of either a transmitterreceiver link or a bulkhead/splice over
a 600 grit polish alone. This fine polish is comparable to the
Avago factory polish. The fine polishing step may be omitted
where an extra 2 dB of optical power is not essential, as with
short link lengths. Proper polishing of the tip of the fiber/con
nector face results in a tip diameter between 2.5 mm (0.098
in.) minimum and 3.2 mm (0.126 in.) maximum..
HFBR-4593 Polishing Kit