EPAX0500 Red Lion Controls, EPAX0500 Datasheet - Page 4

• Manufacturer Part Number: EPAX0500
• Description: Multifunction Meter
• Manufacturer: Red Lion Controls
• Type: Multi-Functionr

Specifications of EPAX0500

• No. Of Digits / Alpha: 5
• Panel Cutout Height: 6.23"
• Panel Cutout Width: 23.79mm
• Signal Input Type: Current, Process, Strain Gage, Thermocouple, Voltage
• Meter Signal Input: Current, Process, Thermocouple, Voltage
• Application: For industrial
• Connection Type: Cage-Clamp
• Cut Out, Panel: 23.79×6.23 "
• Digit Height: 0.35
• Dimensions: 24.77"L×4.65"W×7.22"H
• Display Digit Height: 4 "
• Display Type: LED
• Function: Ammeter/Process/Strain Gage/Temperature/Voltage
• Humidity: 0 to 85%
• Material, Casing: Aluminum
• Number Of Digits: 8
• Primary Type: Electronic
• Range, Measurement: -19999 to 99999
• Temperature, Operating: 0 to +50 °C
• Termination: Cage Clamp
• Voltage, Input: 85 to 250 VAC
• Voltage, Supply: 85 to 250 VAC
• Sealing: NEMA 4/IP65
• Character Size: 4"
• Color: Red
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: Red Lion MPAXD000, MPAXH000, MPAXP000 And MPAXT000 MPAX Modules

EPAX DISPLAY INSTALLATION
into a panel or enclosure. The display is provided
with a gasket to provide a water-tight seal. The
recommended minimum panel thickness for
NEMA 4/IP65 sealing is 0.060" (1.57 mm).
cut-out to the dimensions shown in
Figure 3. The supplied template may be
used to mark the cut-out and hole
locations on the panel. After the panel
cut-out has been deburred, slide the
panel gasket over the rear of the display
and onto the mounting studs. Insert the
display into the panel cut-out as
illustrated in Figure 4. Install 14 # 10-32
keps nuts (supplied) and tighten evenly
for uniform gasket compression. Do not
over-tighten the nuts.
the EPAX can be surface-wall mounted,
suspended, or bottom mounted. Separate installation
instructions are provided with the mounting accessories.
Environment And Cleaning
the maximum operating temperature and provides good air
circulation. Placing the system near devices that generate
excessive heat should be avoided.
neutral soap product. Do NOT use solvents. Continuous
exposure to direct sunlight may accelerate the aging
process of the bezel.
2.0 INSTALLING THE DISPLAY
The EPAX display is intended to be mounted
For panel mounting, prepare the panel
By using additional mounting accessories,
The display should be installed in a location that does not exceed
The bezel should be cleaned only with a soft cloth and
DIMENSIONS In inches (mm)
Figure 3, Panel Cut-out for the EPAX
4
Figure 4, Installing The EPAX Into A Panel