WV408-2000.V1 EUROTHERM CONTROLS, WV408-2000.V1 Datasheet - Page 2

• Manufacturer Part Number: WV408-2000.V1
• Description: Isolating Signal Conditioner
• Manufacturer: EUROTHERM CONTROLS

Specifications of WV408-2000.V1

• Width: 12.7mm
• Isolation Input: Isolated
• Output Accuracy: ±0.05% Of FS
• Signal Input Type: Selectable Current Or Voltage
• Supply Voltage: 24VDC
• Configuration Setup: DIP Switch
• Iso-amp Mounting Type: DIN Rail
• Rohs Compliant: NA
• Dc / Dc Converter O/p Type: Adjustable
• Display Alarm Type: 2 Relay
• Input Accuracy: ±0.015% Of FS

2
DESCRIPTION
The Ultra SlimPak II is an exciting new line of isolating
signal conditioners from Action Instruments with
greater accuracy and better stability than virtually any
other signal conditioners on the market today. The
Ultra SlimPak II also features "Smart Power" to reduce
power consumption and temperature rise. These units
are configured using DIP switches and feature
pushbutton calibration just like the familiar Action I/Q
series.
SMART POWER
Smart Power adjusts the output voltage and current,
depending on the power output required to drive
the current load. A low impedance current loop will
subsequently use less power than a high impedance
current loop. Previous designs provide only a single
supply at the highest voltage required to drive the
highest impedance load. Smart Power can save as
much as 1/2 Watt per unit and reduce the operating
temperature as well.
Ultra SlimPak II
The Latest Technology in Signal Conditioners
BENEFITS
• Lower Power Requirements with “Smart Power” Control
• The Best Input/Output Accuracy and Stability Available
• Field Configurable
• Integral Diagnostic Capability
• Versatile Alarm Capabilities Provide
E-mail Notification when Problems Occur
-
-
-
Input Accuracy of 0.015%
Output Accuracy of 0.05%
Stability of 100ppm
ENHANCED DIAGNOSTIC LEDS
Blinking LEDs communicate the following information:
GREEN
RED:
CONFIGURATION
In addition to the DIP switches and pushbutton, it is
possible to remotely configure each module, using
an Ethernet connection to the WVC16 and a remote
PC-based web browser.
INTEGRAL DIAGNOSTICS
Besides the four diagnostic LED's, further diagnostic
information can be obtained using a computer. All
Ultra SlimPak II units can provide HI/LO and over-
temperature soft alarms when used with a WVC16
communications interface.
2Hz when the input is under range
8Hz when the input is over range
2Hz when the output is under range
8Hz when the output is over range
Ultra SlimPak II