XLNPC B&K Precision, XLNPC Datasheet - Page 18

• Manufacturer Part Number: XLNPC
• Description: XLN Power Cord
• Manufacturer: B&K Precision

Specifications of XLNPC

• Cable Assembly Type: Power Cord
• Equipment Type: Power Cord
• Accessory Type: Power Cord
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: na
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, na

2.7
2.8
2.9
The XLN series is fully operable upon switching the power on. However, to
reach the specified equipment accuracy, please allow the supply to warm up
for at least 30 minutes.
When the supply is not in use, be sure to turn the power switch on the panel
to the OFF position to turn off the power. After the power switch is turned to
the OFF position, the inner fans will still run for approximately 10-15
seconds to carry on the inside electric capacitor discharge process per safety
code requirement. Once the discharge process is complete, this product will
carry out the automatic shut-down process
A. While connected in series, each power supplies should be in power-on
B. While in parallel connection mode, the output voltage of each power
C. When the AC input voltage is lower than the full-load voltage which is
state and output should be "ON". In case there is any one supply that is
in power-off state or output is "OFF", the associated output current will
flow over the output bypass diode of the power-off unit and burn it out.
supplies should be set to equal values. If the setting value of each unit is
not the same, the higher output voltage will feed back to the smaller unit
and destroy its inner parts.
100 VAC, the supplies will activate an inner over temperature protector
and cut off the output in response to the condition. To ensure that the
entire test process can be complete smoothly, confirm that the input AC
voltage is within the specified range.
Warm-up Time
Power-off procedure
Cautions in Operation
11