07-AP892 ABLE SYSTEMS, 07-AP892 Datasheet - Page 6

• Manufacturer Part Number: 07-AP892
• Description: PRINTER, IMPACT PORTABLE
• Manufacturer: ABLE SYSTEMS

Specifications of 07-AP892

• Interface: Serial RS-232
• Print Speed: 1.7 Lines/sec
• Svhc: No SVHC (18-Jun-2010)
• External Depth: 158mm
• External Length / Height: 104mm
• External Width: 82mm
• Weight: 640g
• Interface Type: Serial RS-232
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

4
4.1
The options for powering the Ap890 may be sumarised as follows:
In each case the Ap890 requires data input from a host, as illustrated in the sketches below:
All three options are housed in the same type of replaceable pack, which clips into the underside of
the printer and can be changed in a few seconds by the user. In each case, the primary power for the
printer comes from this replaceable pack.
When used with a battery pack (option A), the printer can operate with, or without, an external charger
connected. If required, the charger can be operated continuously to keep the battery fully charged,
although a high printing duty cycle may reduce the charge in the battery.
N.B. Operation from the charger alone is not possible: a battery pack must always be fitted.
Battery packs are normally supplied discharged for safety reasons.
When the Ap890 is used with the direct mains powered PSU (option B), or the direct vehicle adaptor
(option C), an external charger is not required. However, making a connection to the ‘Charger’ input
will not damage the printer, and may be used to force the Ap890 to wake and sleep as required.
4.2
To Remove the pack from the printer:
To Replace the pack:
BATTERY PACKS AND POWER SUPPLIES
OVERVIEW OF POWER PACK OPTIONS
REMOVING AND REPLACING THE POWER PACK
A. a battery pack, (see section ‘4.5 Battery Pack Types And Capacity’), with optional
B. a direct mains powered PSU (Universal mains input with 3-pin IEC mains socket)
C. a direct vehicle adaptor suitable for direct connection to a vehicle supply
§
§
§
§
WARNING! Refer to section ‘4.3 Battery Pack Handling Precautions’.
external charger (see section ‘7.3 Battery Charger Details’), and optional cable (see
section ‘7.2 Combined Data/Charger Adaptor Cables‘)
(ASL Product Code AP800-PSA)
(ASL Product Code AP800-DCC)
Lift the rear edge (marked by three moulded bars) and overcome the "click" detent. This
may be quite stiff with a new printer and pack.
Slide the pack towards the rear of the printer, and lift it out.
The pack will only fit one way. First insert the edge with the gold metallic contacts, and
then tilt the rear (sloping) edge downwards so that the pack enters the printer recess in a
sliding motion. Press the pack into the printer until a distinct "click" is felt.
After replacement of the pack, the printer will be in sleep mode.
(A)
Ap890 and Ap892 User Guide Page 6 of 12
(B)
Section Continues…
(C)