11-71315-225-01 3M, 11-71315-225-01 Datasheet - Page 23

• Manufacturer Part Number: 11-71315-225-01
• Description: CT 150 USB CONNECTION WITHOUT BEZEL, POWER SUPPLY INCLUDED
• Manufacturer: 3M
• Series: C1500SSr
• Type: Capacitiver

Specifications of 11-71315-225-01

• Length: 12" (304.1mm)
• Width: 14" (350.4mm)
• Height: 9" (228.1mm)
• Interface: USB
• Diagonal Screen Size: 15" (380mm)
• Lead Free Status / Rohs Status: Details

3M™ MicroTouch™ Display C1500SS Installation Guide
Troubleshooting the Touch Sensor
Table 3. Common Touch Sensor Installation Issues
Common Installation
Issues
Touch sensor does not
respond to touch
Touch sensor is not
accurate
Cursor does not follow
finger movement or does
not reach the edges of the
sensor
Cursor is not located
directly underneath your
finger
Cursor is extremely jittery
or erratic
Cursor lags finger
Power Management
If you are experiencing problems with the touch sensor, check the following list of
common installation errors.
The C1500SS Display conforms to the Video Electronics Standards Association (VESA)
Display Power Management Signaling (DPMS) standard. To benefit from power
management, the display must be used in conjunction with a computer and video card
that implements the VESA DPMS standard.
The PC automatically invokes the power management feature if you do not use the touch
sensor, mouse, or keyboard for a user-defined period. To restore the video image, simply
touch the sensor, press a key, or move the mouse. To set the period of time after which
the PC will invoke the power management feature, refer to the user manual that came
with your video card or PC.
Possible Solutions
• Review the installation procedures. Are all cables connected
• After you installed Touch Software, did you restart your PC to
• Are the communication settings correct? Is the touch sensor
Calibrate the touch sensor for the current video resolution and
operating system.
Calibrate the touch sensor for the current video resolution and
operating system.
• Open the touch sensor control panel and make sure all cursor
• Calibrate the touch sensor for the current video resolution and
Stabilize the cursor by adjusting the operating frequency of the touch
controller.
Lower the baud rate of the touch controller and the touch driver.
properly?
activate the touch sensor driver?
trying to use the same COM port or IRQ as another device (for
example, a mouse)? If so, a hardware device conflict will result
and the touch sensor will not work.
offsets (vertical, edge/horizontal) are turned off.
operating system.
3M Touch Systems Proprietary Information
23