ATB10000 Red Lion Controls, ATB10000 Datasheet - Page 5

• Manufacturer Part Number: ATB10000
• Description: APL-SP 3,4D ACCESS BD "A
• Manufacturer: Red Lion Controls

Specifications of ATB10000

• Rohs Compliant: NA

ACCESSORY BOARD POWER CONNECTIONS
“COMMON” of Terminal Block A (TBA). The voltage applied to the
terminals depends on the “Voltage Version” that is being installed. Check to be
sure that you have the proper unit for your application. Refer to the preceding
diagrams to determine which terminal is to be used.
INSTALLATION ENVIRONMENT
maximum operating temperature and provides good air circulation. Placing
the unit near devices that generate excessive heat should be avoided.
product. Do NOT use solvents. Continuous exposure to direct sunlight may
accelerate the aging process of the bezel.
The DC power to the unit is applied between “V1” or “V2” and
The unit should be installed in a location that does not exceed the
The bezel should be cleaned only with a soft cloth and neutral soap
5
ACCESSORY BOARD INSTALLATION
Apollo Slave Display. The accessory board can be installed before or after the
unit has been installed into the panel. Install the four self-retaining spacers into
the four holes on the accessory board as shown in the diagram. Mount the
accessory board onto the Slave Display. Install the four screws through the
spacers and carefully tighten them until they are snug.
INSTALLATION
installed. The units are intended to be mounted into an enclosed panel with a
gasket to provide a water-tight seal. Two mounting clips and screws are
provided for easy installation. Consideration should be given to the thickness
of the panel. A panel which is too thin may distort and not provide a water-
tight seal. (Recommended minimum panel thickness is 1/8".)
gasket over the rear of the unit to the back of the bezel. Insert the unit into
the panel. As depicted in the drawing, install the screws into the narrow end
of the mounting clips. Thread the screws into the clips until the pointed end
just protrudes through the other side.
inserting the wide lip of the clips into
the wide end of the hole, located on
either side of the case. Then snap the
clip onto the case. Tighten the screws
evenly to apply uniform compression,
thus providing a water-tight seal.
CAUTION: Only minimum pressure is
required to seal panel. Do NOT
overtighten screws.
The optional accessory board (ATB) is mounted directly to the rear of the
The unit meets NEMA 4/IP65 requirements for indoor use, when properly
After the panel cut-out has been completed and deburred, slide the panel
Install each of the mounting clips by