AFCT-701ASDZ Avago Technologies US Inc., AFCT-701ASDZ Datasheet - Page 14

• Manufacturer Part Number: AFCT-701ASDZ
• Description: 10GbE SFP+ LR, RoHS (0-85degC)
• Manufacturer: Avago Technologies US Inc.

Specifications of AFCT-701ASDZ

• Data Rate: 10.312Gbd
• Wavelength: 1310nm
• Applications: Ethernet
• Voltage - Supply: 3.135 V ~ 3.465 V
• Connector Type: LC Duplex
• Mounting Type: SFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Table 11. Transceiver Digital Diagnostic Monitor (Real Time Sense) Characteristics
The following characteristics are defined over the Recommended Operating Conditions unless otherwise noted.
Parameter
Transceiver Internal Temperature
Transceiver Internal Supply
Voltage
Transmitter Laser DC Bias Current
Transmitted Average Optical
Output Power
Received Average Optical Input
Power
Figure 5. Transceiver timing diagrams (module installed and power applied except where noted)
14
t-init: TX DISABLE NEGATED, MODULE HOT PLUGGED
t-init: TX DISABLE NEGATED
t-fault: TX DISABLE ASSERTED THEN NEGATED, TX SIGNAL NOT RECOVERED
t-fault: TX FAULT OCCURED
* SFP SHALL CLEAR TX_FAULT IN
< t_init IF THE FAILURE IS TRANSIENT
TRANSMITTED SIGNAL
TRANSMITTED SIGNAL
TRANSMITTED SIGNAL
OCCURANCE OF FAULT
V
TRANSMITTED SIGNAL
OCCURANCE OF FAULT
V
CC
CC
T, V
T, V
CC
TX_DISABLE
CC
TX_DISABLE
TX_DISABLE
TX_FAULT
R > 2.97 V
TX_FAULT
TX_DISABLE
R > 2.97 V
TX_FAULT
TX_FAULT
INSERTION
t_init
t_reset
t_init
t_fault
Symbol
T
V
I
P
P
t_fault
INT
INT
T
R
INT
t_init*
Min.
±3.0
±0.1
±10
±3.0
±3.0
Units
°C
V
%
dB
dB
t-off & t-on: TX DISABLE ASSERTED THEN NEGATED
t-init: TX DISABLE ASSERTED
t-reset: TX DISABLE ASSERTED THEN NEGATED, TX SIGNAL RECOVERED
t-los-on & t-los-off
* SFP SHALL CLEAR TX_FAULT IN
Notes
Temperature is measured internal to the transceiver.
Valid from = -10°C to 85°C case temperature.
Supply voltage is measured internal to the transceiver
and can, with less accuracy, be correlated to
voltage at the VccT contact. Valid over 3.3 V ± 10%.
I
Average Power coupled into 9/125 μm single-mode
fiber. Valid from151 μW to 1120 μW.
Average Power coupled from 9/125 μm single-mode
fiber. Valid from 25 μW to 1120 μW.
< t_init IF THE FAILURE IS TRANSIENT
INT
TRANSMITTED SIGNAL
TRANSMITTED SIGNAL
accuracy is better than ±10% of the nominal value.
TRANSMITTED SIGNAL
OCCURANCE OF FAULT
V
CC
T, V
OPTICAL SIGNAL
TX_DISABLE
CC
TX_DISABLE
TX_DISABLE
TX_FAULT
TX_FAULT
R > 2.97 V
TX_FAULT
LOS
t_loss_on
t_off
t_reset
OCCURANCE
OF LOSS
t_init
t_init*
t_on
t_loss_off