MGA-43328-TR1G Avago Technologies US Inc., MGA-43328-TR1G Datasheet - Page 15

• Manufacturer Part Number: MGA-43328-TR1G
• Description: 29dBm Linear PA 2.5-2.7GHz
• Manufacturer: Avago Technologies US Inc.

Specifications of MGA-43328-TR1G

• Current - Supply: 470mA
• Frequency: 2.5GHz ~ 2.7GHz
• Gain: 37.3dB
• Noise Figure: 2.1dB
• P1db: 35.5dBm
• Package / Case: 28-VFQFN Exposed Pad
• Rf Type: 802.16 WiMAX
• Test Frequency: 2.6GHz
• Voltage - Supply: 5V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Application Schematic
Figure 36. Application schematic in demonstration board
Notes:
1. In normal gain mode operation, Vbyp = 0V. Vc1, Vc2 and Vc3 are bias pins that are used to set the bias conditions to the 3 internal gain stages of
2. Typical quiescent current distribution with Vdd1 = Vdd2 = Vdd3 = Vbias = 5V, Vbyp = 0V, Vc = 2.1V is :
3. Low gain mode is enabled by setting Vbyp pin to 5V. This condition overrides the normal high gain mode operation and bypasses the first gain
4. Modulated signal measurements are made with Agilent 89600 VSA and Agilent E4438C signal generator with IEEE 802.16e option using the
5. Typical operating voltages and currents:
6. Vdd1/2/3 are shown as separate supplies with individual bypass capacitors. This yields the most stable configuration. If a common power supply
15
the PA.
a. Idd1 = 55.5 mA
b. Idd2 = 146 mA
c. Idd3 = 268.5 mA
d. Ibias = 16.5mA
(Note: Vc supplied through Vc2 pin on demonstration board with R2 = 1.0k: , R3 = 390: and R4 = 1.1k:)
stage, regardless of the voltage at Vc1 pin.
following test conditions :
– Signal format: IEEE 802.16e OFDMA, ¾ rate FEC
– Modulation: 64-QAM
– Number of Subcarriers: 840
– Modulation bandwidth: 10 MHz
– Downlink ratio: 50%
Residual distortion of signal generator: (0.6-0.8)%. This distortion is not removed from the overall EVM data in the datasheet.
a. Normal gain mode : Vdd1 = Vdd2 = Vdd3 = Vbias = 5V. Vc = 2.1V. Vbyp = 0V. Iq(total) = 470 mA.
b. Low gain mode : Vdd1 = Vdd2 = Vdd3 = Vbias = 5V. Vc = 2.1V. Vbyp = 5V. Iq(total) = 470 mA.
line is used, proper broadband bypass decoupling is recommended to reduce common mode feedback through the supply line.