SSB-2 QUAM NICHOLS, SSB-2 Datasheet - Page 3

• Manufacturer Part Number: SSB-2
• Description: Mounting Bracket
• Manufacturer: QUAM NICHOLS

Specifications of SSB-2

• For Use With: SSB Series Loudspeakers
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

SSB-2 Loudspeaker Assembly Support (Tile Bridge) for Ceiling Tile Installations
For all QUAM 8” Loudspeakers and others.
INTENDED USE:
Indoor environment, mounted parallel to floor plane
in a 24” wide suspended ceiling tile grid.
Used with compatible round and square baffles
with stud or screw mount.
Select your installation option from the list below:
1. BACKBOX and
2. ROUND Baffle Installation
3. SQUARE Baffle Installation
© 2011 Quam-Nichols Company Quam-Nichols reserves the right to make changes and/or improvements to its products at any time and without notice.
Figure "A"
- Cut 8-1/2” square hole in tile using tile bridge as
- Position tile bridge on TOP of tile, legs like:
- Install speaker /baffle on opposite of ceiling tile and
- Cut 8-1/2” square hole in tile using tile bridge as
- Position tile bridge on TOP of tile, legs like:
- Bend 8x locator tabs around tile in opening
- Install speaker /baffle on opposite of ceiling tile and
Bend 8x locator tabs around tile in opening
Figure B: Move ‘J-nuts from Pos. 1 to Pos. 2
- Refer to back box instructions for details
Complete Tile preparation and Baffle installation with
either instructions #2 or #3
fasten to tile bridge/tile assembly with 4x #8-32
screws provided with speaker/baffle assembly.
a template, with accessory cuts as shown in
Figure B to access “J-nuts”.
fasten to tile bridge/tile assembly with 4x #8-32
screws provided with speaker/baffle assembly.
a template as shown Figure A.
ROUND or SQUARE
o
CEILING T ILE
CENTER
without
I N S T A L L A T I O N
without
234 East Marquette Road, Chicago, IL 60637
Phone: (800) NEED NOW
E-Mail: [e-mail]
Baffle Installation
back can:
(800) 633 - 3669
back can:
V
V
o
MARK AND CUT
TABS (8)
:
Tie-off
point
Fax: (888) NEED NOW
2x
I N S T R U C T I O N S
- Refer to loudspeaker assembly for proper termination,
- Insulate all unused taps from each other, the enclosure
NOTE! AHJ/ local codes may require tie-off to structure.
Tie-off to tile bridge frame using hole provided; see arrow
on diagram.
NOTE! AHJ/ local codes may require tie-down to grid
Create a hole in the T-bar next to the end of the tile bridge
rails; secure with wire through the hole in the end of the
(888) 633 - 3669
www.quamspeakers.com
Figure "B"
or go to
and electrical ground.
www.QuamSpeakers.com / Resources/ Wiring
o
o
CEILING T ILE
CENTER
11-3.24
o
6 7 8 6
MARK AND CUT
POSIT ION #2
TABS (8)
POSIT ION #1