LEWES-S4 QUASAR, LEWES-S4 Datasheet - Page 2

• Manufacturer Part Number: LEWES-S4
• Description: REMOTE CONTROL, AM, 4 CHANNEL
• Manufacturer: QUASAR

Specifications of LEWES-S4

• Kit Features: AM System, Complete Remote Control System, 4 Channels, High Security Radio Protocol
• Svhc: No SVHC (18-Jun-2010)
• Development Tool Type: Hardware / Software - Keyfob
• Tool / Board: RoHS Compliant
• Tool / Board Application: Wireless Access
• Rohs Compliant: Yes

DSLEWES-1
Each output relay provides an isolated switch. Outputs 2 to 4 Connections are Common (COM) and Normally
Open (NO) which close together when activated. Output 1 has an additional Normally Closed (NC) changeover
contact.
The action of the relay outputs is set by the Option link setting Jumper. A link is made / removed by the small
shorting link ‘cap’ placed over the pin header.
Option Link 1 Fitted = Momentary Operation
Option Link 1 Not Fitted = Latching Operation
Please Note: The relay contacts in this unit are for functional use only and must not be used for isolation
purposes
NOTE: You can not erase individual Tx encoders
Data Outputs
Option Links
Learning a New Transmitter Keyfob Switch
1. Briefly short the two ‘learn’ pins on the receiver PCB, the receiver relays will click continuously.
2. Press any transmitter button once, the receiver relays will stop.
3. Press the same transmitter button again, the receiver relays will ‘buzz’ briefly. After a short time delay for reset,
Erasing Existing Transmitters
1. Short the two learn pins on the receiver for 10 seconds then remove the short.
2. The receiver relays will ‘buzz’ briefly after the 10 seconds to indicate the Tx encoder(s) have been erased
this transmitter will operate the system.
Feb 09
Transmitter NOT Operating
Relay Connections when
LEWES R
©2009
EMOTE
Relay Connections when
Transmitter OPERATING
C
ONTROL
Page 2
S
LEARN
OPTION LINK1
OPTION LINK2
OPTION LINK 3
SERIAL DATA OUT
YSTEM