EB023 MATRIX, EB023 Datasheet - Page 5

• Manufacturer Part Number: EB023
• Description: INTERNET BOARD KIT, E-BLOCKS
• Manufacturer: MATRIX

Specifications of EB023

• Development Tool Type: Internet Board Kit
• Kit Features: E-blocks Compatible, Supports 10/100 Base TX, Half/Full Duplex Operation, Auto-negotiation
• Mcu Supported Families: PICmicro
• Tool / Board: RoHS Compliant
• Silicon Manufacturer: Matrix
• Core Architecture: PIC
• Kit Contents: Board
• Features: Supports Auto-Negotiation, E-Blocks Compatible
• Rohs Compliant: Yes

4. Testing this product
1. System Setup
2. PC System Set-up
The following program will test the circuit. The test file can be downloaded from www.matrixmultimedia.com.
The Internet board is connected direct to a PC using a standard RJ45 CAT 5 cross-over cable, as shown in the
example below: -
Multi-programmer board (EB006) with:
The cable between the PC Ethernet connector and the internet board is a crossover cable.
Note that the details here may vary from Operating System to Operating System.
If the PC has been configured for use on a Local Area Network you may need to configure the PC to have a set IP
address, and to not use Proxy servers.
Copyright © Matrix Multimedia Limited 2005
EB006 Options
Power supply
PICmicro device
SW1 (Fast/Slow)
SW2 (RC/Xtal)
Xtal frequency
Port A
Port B
Port C
Port D
Port E
Test program
EB005 Options
Patch jumper setting
EB023 Options
Patch jumper setting
Voltage selector J 5
Address jumper J8
Address jumper J9
Address jumper J10
External, 14V
LCD board EB005
Internet board EB023
DEFAULT
Setting
16F877A
Don’t care
Xtal
19.6608MHz
Switch board EB007
EB023_test.hex
Setting
Setting
A
5V
1
1
1
E-blocks™ internet board
Document code: EB023-30-1
page 5