49904 Loctite, 49904 Datasheet - Page 3

• Manufacturer Part Number: 49904
• Description: ETHYL CYANOACRYLATE ADH, TUBE, 3G
• Manufacturer: Loctite
• Series: 499r

Specifications of 49904

• Adhesive Type: Ethyl Cyanoacrylate
• Color: Clear
• Dispensing Method: Tube
• Weight: 3g

Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.
Hazardous components
Ethyl 2-cyanoacrylate
Treated fumed silica
Thickener
IDH number: 234181
Physical state:
Color:
Odor:
Odor threshold:
pH:
Vapor pressure:
Boiling point/range:
Melting point/ range:
Specific gravity:
Vapor density:
Flash point:
Flammable/Explosive limits - lower:
Flammable/Explosive limits - upper:
Autoignition temperature:
Evaporation rate:
Solubility in water:
Solubility in water:
Partition coefficient (n-octanol/water):
VOC content:
Handling:
Storage:
Engineering controls:
Respiratory protection:
Eye/face protection:
Skin protection:
For information on product shelf life contact Henkel Customer Service at [phone].
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
9. PHYSICAL AND CHEMICAL PROPERTIES
7. HANDLING AND STORAGE
Respirable fraction.
10 mg/m3 TWA
Inhalable dust.
3 mg/m3 TWA
0.2 ppm TWA
ACGIH TLV
Product name: 499 Super Bonder® Thermal Cycling Resistant Instant Adhesive
Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist.
Wash thoroughly after handling. Avoid contact with fabric or paper goods.
Contact with these materials may cause rapid polymerization which can
generate smoke and strong irritating vapors, and cause thermal burns.
Keep in a cool, well ventilated area away from heat, sparks and open flame.
Keep container tightly closed until ready for use.
Use positive down-draft exhaust ventilation if general ventilation is insufficient
to maintain vapor concentration below established exposure limits.
Use NIOSH approved respirator if there is potential to exceed exposure
limit(s).
Safety goggles or safety glasses with side shields.
Use nitrile gloves and aprons as necessary to prevent contact. Do not use
PVC, nylon or cotton.
Gel, Liquid
Colorless, Straw
Sharp, irritating
1 - 2 ppm
Not applicable
< 0.2 mm hg
> 300 °F (> 148.9 °C)
Not determined
1.1 at 75 °F (23.89 °C)
3 Approximately
80 - 93.3 °C (176°F - 199.94 °F) Tagliabue closed cup
Not determined
Not determined
485 °C (905°F)
Not available
Polymerises in presence of water.
Soluble
Not applicable
< 2 %; < 20 g/l (California SCAQMD Method 316B) (Estimated)
None
Page 3 of 5
Respirable fraction.
15 mg/m3 TWA
5 mg/m3 TWA
OSHA PEL
Total dust.
None
None
AIHA WEEL
None
None
None
OTHER
None
None
None