CB-OBS433I-02-0 ConnectBlue, CB-OBS433I-02-0 Datasheet - Page 28
![no-image](/images/no-image-200.jpg)
CB-OBS433I-02-0
Manufacturer Part Number
CB-OBS433I-02-0
Description
SERIAL PORT ADAPTER BLUETOOTH
Manufacturer
ConnectBlue
Specifications of CB-OBS433I-02-0
Frequency
2.402GHz ~ 2.48GHz
Data Rate - Maximum
115 kbps
Modulation Or Protocol
Bluetoothv2.1+EDR
Applications
General Purpose
Power - Output
17dBm
Sensitivity
-94dBm
Voltage - Supply
3.3 V ~ 6 V
Current - Receiving
200mA
Current - Transmitting
200mA
Data Interface
Connector, 2 x 10 Header, 2 mm Pitch
Antenna Connector
On-Board, Chip
Operating Temperature
-40°C ~ 85°C
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
809-1038
connectBlue
Copyright © 2010 connectBlue AB
In accordance with 47 CFR § 15.19 the end product shall bear the following statement in a conspicuous location on the device:
"This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation."
When the device is so small or for such use that it is not practicable to place the statement above on it, the information shall be placed in
a prominent location in the instruction manual or pamphlet supplied to the user or, alternatively, shall be placed on the container in which
the device is marketed. However, the FCC ID label must be displayed on the device.
In case, where the final product will be installed in locations where the end-user is not able to see the FCC ID and/or this statement, the
FCC ID and the statement shall also be included in the end-product manual.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter. As long as these conditions above are met, further
transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then
the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the
OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
If a customer intends to UL list a product including any of the Bluetooth modules based on the PCB cB-0939 this information is useful:
The printed circuit board if produced according to the following specification:
All products based on the PCB cB-0939 are produced according to the RoHS (Restriction of the use of certain Hazardous substances in
electrical and electronic equipment) directive and complies with the directive.
8.4 UL listing information
8.5 Compliance with RoHS directive
8.3.1.6 RF-exposure Statement for cB-0939
UL recognized ZPMV2 min. 105 °C flame class V-0 or better.
Page 28 of 42