0638190800 Molex Inc, 0638190800 Datasheet - Page 6

• Manufacturer Part Number: 0638190800
• Manufacturer: Molex Inc
• Type: Hand Crimp Toolr

Specifications of 0638190800

• Lead Free Status / RoHS Status: RoHS Not Applicable

Hand Crimp Tool For .062” Pin and Socket, SPOX™ and KK® High Pressure Crimp Terminals
Doc No: ATS-638190800
Revision: B
Right or Left Hand Operation
This hand tool has an added feature that can be
converted from a right handed application to a left
handed application. It is necessary to reverse the
tooling if using the left handed application along with the
locator. Follow the steps below:
1. The locator must be removed before reversing the
2. Remove the M3 BHCS which is holding the upper tooling.
3. Flip the upper tooling to the opposite side and replace the M3 BHCS.
4. Do the same thing with the lower tooling and tighten the M3 screws. Be
5. Reinstall the locator by following the Instructions in the locator replacement
Maintenance
It is recommended that each operator of the tool be made aware of, and
responsible for, the following maintenance steps:
1. Remove dust, moisture, and other contaminants with a clean brush, or
2. Do not use any abrasive materials that could damage the tool.
3. Make certain all pins; pivot points and bearing surfaces are protected with a thin coat of high quality machine
4. Wipe excess oil from hand tool, particularly from crimping area. Oil
5. When tool is not in use, keep the handles closed to prevent objects from
Miscrimps or Jams
Should this tool ever become stuck or jammed in a partially closed position,
Do Not force the handles open or closed.
pressing up on the ratchet release lever in the movable handle. See Figure 9.
tooling.
Make sure the small markings on the front and back of the hand tool frame
match up and are on the outside of the hand tool frame. See Figure 11
and 12.
sure the small markings line up.
section.
soft, lint free cloth.
oil. Do not oil excessively. The tool was engineered for durability but like any other equipment it needs
cleaning and lubrication for a maximum service life of trouble free crimping. Light oil (such as 30 weight
automotive oil) used at the oil points, every 5,000 crimps or 3 months, will significantly enhance the tool life.
transferred from the crimping area onto certain terminations may affect
the electrical characteristics of an application.
becoming lodged in the crimping dies, and store the tool in a clean, dry
area.
Release Date: 10-25-07
Revision Date: 03-09-08
The tool will open easily by
UNCONTROLLED COPY
FRONT
UP MARKS
(BOTH SIDES) LIGHT OIL
LUBRICATION POINTS
(EVERY 3 MONTHS OR
MATCH
Figure 12
5,000 CRIMPS)
Figure 8
RATCHET RELEASE
LEVER
BACK
Figure 9
Page 6 of 9