0638190800 Molex Inc, 0638190800 Datasheet - Page 7

• Manufacturer Part Number: 0638190800
• Manufacturer: Molex Inc
• Type: Hand Crimp Toolr

Specifications of 0638190800

• Lead Free Status / RoHS Status: RoHS Not Applicable

Hand Crimp Tool For .062” Pin and Socket, SPOX™ and KK® High Pressure Crimp Terminals
Doc No: ATS-638190800
Revision: B
How to Adjust Tool Preload
This hand tool is factory preset to 25-45 LBS. preload. It may be necessary over the life of the tool to adjust tool
handle preload force. Listed below are the steps required to adjust the crimping force of the hand tool to obtain
proper crimp conditions:
1. Hold the hand tool in the palm of
2. Rotate the setting wheel counter-
3. Release the link to lock the setting
4. Check the crimp specifications or
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long life tested. All tools are warranted to be free of manufacturing defects for a period of 30
days. Should such a defect occur, we will repair or exchange the tool free of charge. This repair or exchange will
not be applicable to altered, misused, or damaged tools. This tool is designed for hand use only. Any clamping,
fixturing, or use of handle extensions voids this warranty.
CAUTIONS:
1. Manually powered hand tools are intended for low volume or field repair. This tool is
2. Insulated rubber handles are not protection against electrical shock.
3. Wear eye protection at all times.
4. Use only the Molex terminals specified for crimping with this tool.
your hand as shown in Figure 10.
Using the index finger squeeze the
link towards the top of the hand
tool frame. This will release the
preload adjustment wheel.
clockwise (CCW) to increase
handle force. The numbers will
display higher. To decrease
handle force rotate the setting
wheel clockwise (CW).
wheel in place.
conduct a pull test after tool handle preload force is adjusted.
production use. Repetitive use of this tool should be avoided.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.
Release Date: 10-25-07
Revision Date: 03-09-08
(See Figure 10)
SETTING
WHEEL
UNCONTROLLED COPY
RELEASE LEVER
RATCHET
THE HANDLE
THE LINK IN
SQUEEZE
NOT
Figure 10
intended for
TOOL IN POSITION
HOLD THE HAND
Page 7 of 9