ST7MDT25-TEB/DVP STMicroelectronics, ST7MDT25-TEB/DVP Datasheet - Page 31

• Manufacturer Part Number: ST7MDT25-TEB/DVP
• Description: BOARD TARGET EMULATION ST7-DVP3
• Manufacturer: STMicroelectronics

Specifications of ST7MDT25-TEB/DVP

• Accessory Type: Target Board
• Processor To Be Evaluated: ST72561
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: ST7MDT25-DVP3 Emulator
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

ST7-DVP3 Emulator User Manual
5 Insert the TEB’s two 60-pin connectors into the connectors J5 and J6 on the
6 Secure TEB to the MEB by tightening the two nuts back in place, as shown in
7 Using the appropriate flex cables and probe for your target MCU, reconnect
8 Reconnect your power supply and power up your ST7-DVP3 emulator and your
Flat cable connectors
TEB you will find the flat cable connectors (number and size will vary depending
on the TEB).
MEB. Because of the orientation guides on these connectors, there is only one
possible connection scheme.
Figure 15
your ST7-DVP3 emulator to your application board, as described in your
ST7xxx-DVP3 Probe User Guide .
application. For details refer to
J6
. Be careful not to overtighten them.
Figure 15: Install the replacement TEB
Section 2.2
J5
on page 10.
Appendix B: Changing the TEB
31/44