REP430F Elprotronic Inc., REP430F Datasheet - Page 13

• Manufacturer Part Number: REP430F
• Description: Programmers & Debuggers MSP430 MCU Replicatr
• Manufacturer: Elprotronic Inc.

Specifications of REP430F

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

4.4 Options switch
configuration:
to the MSP430F5437 MCU and supply it. When this option is used, then no external power
supply is required for the REP430F. Current provided from programming adapter should be
higher than 30mA. This option is useful for debugging.
position then the Vpp 6.5V can be used to blow the security fuse. If the Vpp switch is in the
“OFF” position then the Vpp 6.5 V is off and the physical fuse in the MSP430F1xx, F2xx
and F4xx cannot be blown regardless of other software options. However, the fuse can be
blown if the MSP430F5xx or F6xx microcontrollers are used. Position of the Vpp switch can
be detected by the software.
detection - Mode0, (00), Mode-1 (01), Mode-2 (10) and Mode-3 (11). Type of modes are
related to software as an extra options.
4.5 LEDs
*
*
*
REP430F -
Option switch contains the following four switches to modify the replicator’s
*
*
*
*
Switch J-V allows to connect the Vcc from the host programming adapter directly
Switch Vpp is used for blowing the JTAG security fuse. If this switch is in the “ON”
Switches M-0 and M-1 are connected directly to MCU and can be used for mode
The REP430F contains five LEDs.
3V
Vcc
RUN - Yellow LED - controlled by software - indicates in progress status
User Guide
J-V
Vpp
M-1
M-0
- Yellow LED - is connected directly to internal 3V and indicate the presence
of the REP430 power supply
- Green LED - is connected directly to target’s Vcc and indicate presence of
the power supply on target device. The LEDs intensity can vary vs value of
the Vcc (2.1 to 3.6V) on the target device.
(running)
- supply enable the replicator from host programming adapter
- Vpp (6.5V) for blow the security fuse enable
- mode - 1
- mode - 0
PM041A01 Rev.0
13