DLP-RF1-Z DLP Design Inc, DLP-RF1-Z Datasheet - Page 4

• Manufacturer Part Number: DLP-RF1-Z
• Description: Zigbee / 802.15.4 Modules & Development Tools PC INTERFACE HOST MODULE (USB)
• Manufacturer: DLP Design Inc

Specifications of DLP-RF1-Z

• Wireless Frequency: 2.4 GHz
• Interface Type: USB
• Operating Voltage: 9 V
• Antenna: Integral to PCB Design?No External
• For Use With/related Products: MC13193, MC9S08GT60
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

EEPROM CONTENTS
2.3 Command Set
This Command Set is a feature of the preprogrammed SIPP firmware and, as such, is only available if
using the DLP-RF1 with its firmware as shipped from DLP Design.
Packets are broken down into two primary types: Command Packets and Reply Packets. The host
controller/PC originates all Command Packets. In the case of the DLP-RF1, the host is the user-supplied
host PC and associated application program.
If a Command Packet is received by the DLP-RF1 via USB with a destination ID that matches the ID
stored in the EEPROM of the DLP-RF1, then the MC9S08GT60 will process the packet and reply to the
host PC. If the ID in the packet does not match the ID stored in EEPROM, then the packet is intended
for a different destination and is transmitted via the transceiver.
Rev 1.5 (November 2005)
Byte Description
31
0
1
2
3
4
5
6
7
8
9
My ID MSB
My ID LSB
Transceiver
Channel
RF Transmit Power
Sleep Time Length
MSB (DLP-RF2
Low-Power Mode
Only)
Sleep Time Length
LSB
Wake from Sleep,
Host Command
Timeout after
Check-in (DLP-RF2
in Low-Power Mode
Only)
Baud rate for RF1-Z
and RF2 Host
Controller
Port Pin Bit Field
(DLP-RF2 Only)
DLP-RF2 Available
Features
(DLP-RF2 Only)
Checksum
EX-OR of bytes 0-30
Options
Range: 1-65,535
0-15 (2.405GHz to 2.480GHz)
0-15 (-16.6 to +3.5dBm into the balun)
Range: 1-65,535: 5-second increments,
3.8 days max.
For Example: 1=5 seconds, 12=1
minute, 120=10 minutes, 720=1 hour,
17,280=1day
1-128 half-seconds
0-2400; 1-4800; 2-9600; 3-14400;
4-19200; 5-38400; 6-128000;
7-250000
0x00-0xFF (A6B6B5B4 B3B2B1B0)
Bit 7 – Measures battery voltage
Bit 6 – Temperature sensor
Bit 5 – Relays
Bit 4 – Reserved
Bit 3 – Reserved
Bit 2 – Reserved
Bit 1 – Reserved
Bit 0 – Reserved
4
Default Reset
1 for RF1; 2 for RF2
broadcast commands
7 (2.440 GHz)
15 (+3.5dBm - Max
Power)
5 seconds
2 (4 half-second
intervals)
2 (9600 baud)
0x80; A6 monitored
All bits cleared; no
features available
Calculated
0 reserved for
DLP-RF1/Z DLP Design, Inc.