66597-1 TE Connectivity, 66597-1 Datasheet - Page 4

• Manufacturer Part Number: 66597-1
• Description: III+ PIN,18-14,TIN-LEAD,STRIP
• Manufacturer: TE Connectivity
• Type: Contactr
• Series: Type III+r

Specifications of 66597-1

• Gender: M
• Body Orientation: Straight
• Housing Material: Not Required
• Number Of Contacts: 1POS
• Number Of Ports: 1Port
• Number Of Terminals: 1
• Pitch (mm): Not Requiredmm
• Contact Material: Brass
• Mounting Style: Cable
• Termination Method: Crimp
• Contact Plating: Bright Tin-Lead
• Product Height (mm): 4.24mm
• Product Depth (mm): 4.32mm
• Product Length (mm): 26.75mm
• Rohs Compliant: NO
• Insulation Support: Yes
• Termination Method To Wire/cable: Crimp
• Wire/cable Type: Discrete Wire
• Grade: Commercial
• High Current: No
• Termination End Plating: Bright Tin-Lead
• Pin Diameter (mm [in]): 1.57 [0.062]
• Wire Range (mm [awg]): 0.80-2.00² [18-14]
• Spring Material: Stainless Steel
• Used With: M Series Connectors, CPC Connectors
• Contact Type: Pin
• Contact Classification: Signal
• Contact Plating, Mating Area, Material: Bright Tin-Lead
• Contact Base Material: Brass
• Contact Size: 16
• Rohs/elv Compliance: Not ELV/RoHS compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Accepts Wire Insulation Diameter, Range (mm [in]): 2.79 – 3.81 [0.110 – 0.150]
• Applies To: Wire/Cable
• Test Current (a): 13.0
• Packaging Method: Strip
• Packaging Quantity: 4,000/Reel
• Lead Free Status / RoHS Status: Not Compliant

4.
4.1.
4.2.
4.3.
4.4.
Rev A
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product m eets requirem ents of Figure 1. Failures attributed to
equipm ent, test setup or operator deficiencies shall not disqualify product. W hen product failure occurs,
corrective action shall be taken and sam ples resubm itted for qualification. Testing to confirm corrective
action is required before resubm ittal.
Quality Conform ance Inspection
The applicable quality inspection plan will specify sam pling acceptable quality level to be used.
Dim ensional and functional requirem ents shall be in accordance with applicable product drawing and
this specification.
Sam ple Selection
Sam ples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. All test groups shall each consist of a m inim um of 3 plugs and
3 receptacle connectors from tin and gold plated wire to wire and wire to board product. A
m inim um of 30 contacts shall be selected and identified, unless otherwise specified, these
contacts shall be used for all m easurem ents.
Test Sequence
Qualification inspection shall be verified by testing sam ples as specified in Figure 2.
108-10033-1
4 of 10