CS5376A-IQZR Cirrus Logic Inc, CS5376A-IQZR Datasheet - Page 68

• Manufacturer Part Number: CS5376A-IQZR
• Description: IC LP Multi-Channel Decimation Filter
• Manufacturer: Cirrus Logic Inc

Specifications of CS5376A-IQZR

• Filter Type: Digital
• Number Of Filters: 4
• Max-order: 2nd
• Voltage - Supply: 3 V ~ 5 V
• Mounting Type: Surface Mount
• Package / Case: 64-TQFP, 64-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1778 - EVALUATION BOARD FOR CS5376
• Frequency - Cutoff Or Center: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

19.GENERAL PURPOSE I/O
The General Purpose I/O (GPIO) block provides 12
general purpose pins to interface with external
hardware.
19.1 Pin Descriptions
GPIO[4:0]:CS[4:0] - Pins 32 - 36
Standard GPIO pins also used as SPI 2 chip selects.
GPIO[5:10] - Pins 37, 41 - 45
Standard GPIO pins.
GPIO11:EECS - Pin 46
Standard GPIO pin also used as an SPI 1 chip select
when booting from an external EEPROM.
19.2 GPIO Architecture
Each GPIO pin can be configured as input or out-
put, high or low, with a weak (~200 kΩ) internal
pull-up resistor enabled or disabled. Several GPIO
pins also double as chip selects for the SPI 1 and
SPI 2 serial ports. Figure 36 shows the structure of
a bi-directional GPIO pin with SPI chip select func-
tionality.
When the CS5376A is used as an SPI master, either
when booting from EEPROM using SPI 1 or per-
forming master mode transactions using SPI 2, the
chip select signals from SPI 1 and SPI 2 are logi-
cally AND-ed with the GPIO data bit. The corre-
68
CS output from SPI
Data bit
Figure 36. GPIO Bi-directional Structure
GP_PULL
GP_DATA
GP_DIR
sponding GPIO pin should be initialized as output
mode and logical 1 to produce the chip select fall-
ing edge.
19.3 GPIO Registers
When used as standard GPIO pins, settings are pro-
grammed in the GPCFG0 and GPCFG1 registers.
GP_DIR bits set the input/output mode, GP_PULL
bits enable/disable the internal pull-up resistor, and
GP_DATA bits set the output data value. After re-
set, GPIO pins default as inputs with pull-up resis-
tors enabled.
19.4 GPIO Input Mode
When reading a value from the GP_DATA bits, the
returned data reports the current state of the pins. If
a pin is externally driven high it reads a logical 1, if
externally driven low it reads a logical 0. When a
GPIO pin is used as an input, the pull-up resistor
should be disabled to save power if it isn’t required.
19.5 GPIO Output Mode
When a GPIO pin is programmed as an output with
a data value of 0, the pin is driven low and the in-
ternal pull-up resistor is automatically disabled.
When programmed as an output with a data value
of 1, the pin is driven high and the pull-up resistor
is inconsequential.
Pull Up
Logic
R
GPIO/CS
CS5376A
DS612F4