NS15-KBA04 Omron, NS15-KBA04 Datasheet - Page 124

• Manufacturer Part Number: NS15-KBA04
• Description: Anti-Glare Covr Sheet For NS15
• Manufacturer: Omron

Specifications of NS15-KBA04

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

4-2 1:N Host Connection
4-8
•
Note 1. RS-232C port of Communications Board.
•
Note 1. RS-422A port of Communications Board.
Refer to the manuals of the
Reference
Setting the Front Panel DIP Switch
• Using RS-232C
When using C200HX/HG/HE(-Z), set the DIP switch on the front panel to enable the
Setup Area (Data Memory) settings, as follows:
Built-in RS-232C port of C200HX/HG/HE(-Z) DM 6645
Port A of C200HX/HG/HE(-Z) (See note 1.)
Port 1 of CQM1H (See note 2.)
Port B of C200HX/HG/HE(-Z) (See note 1.)
Port A of C200HX/HG/HE(-Z)
(See note 1.)
Port 2 of CQM1H (See note 2.)
Using RS-232C
Using RS-422A
2. RS-232C port of Serial Communications Board.
3. The PT unit numbers for the C200HE(-Z) are 1 to 3.
2. RS-422A port of Serial Communications Board.
3. The PT unit numbers for the C200HE(-Z) are 1 to 3.
• There is no Communications Board for use with C200HX/HG/HE(-Z) where port B is
• There is
• When setting a 1:N NT Link in the CX-Programmer, set the baud rate to 38,400 bps.
an RS-422A port.
port.
Host type
Host type
Sets the RS-232C port communications
conditions. Set DIP switch pin 5 to OFF to
enable the PLC Setup settings.
no
Communications Board for use with CQM1H where Port 1 is an RS-422A
PLC
being used for details on using the
DM 6555
DM 6550
DM 6555
DM 6550
Address
Address
5@00
5@00
5@00
Write value
Write value
PLC
Uses 1:N NT Link
@: Largest unit number (1
Uses 1:N NT Link
@: Largest unit number (1
to 7) of connected
PTs. (See note 3.)
to 7) of the connected
PTs. (See note 3.)
Setup Area.
Settings
Settings
PLC