NT631C-ST153B-EV3 Omron, NT631C-ST153B-EV3 Datasheet - Page 57

• Manufacturer Part Number: NT631C-ST153B-EV3
• Description: 10.48-ColrDisplay,TFT,Blk,Eng
• Manufacturer: Omron

Specifications of NT631C-ST153B-EV3

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Using a Memory Unit
3-5-1
3-5-2
DIP Switch Functions
40
Installation Method
Method of Use
Note
Install the Memory Unit (NT-MF261) at the expansion interface connector at
the rear of the NT631/NT631C as shown in the figure below (the expansion
interface connector is located underneath the note label.).
As shown in the figure below, a Memory Unit has two sets of four DIP
switches, and the operation is determined by the DIP switches that are set at
startup.
1. Always confirm that the power to the NT631/NT631C is off before setting
2. Do not touch the PCB (printed circuit board) directly with bare hands.
The functions of the DIP switches on the Memory Unit are indicated in the
table below.
SW1
SW1-1
SW1-2
Switch
• One Memory Unit can store a system program for up to two PTs of differ-
• The statuses of memory switch settings and system settings can be
1
OFF
ent models. In order to transmit a system program from the Memory Unit
to the NT631/NT631C, the system program must be compatible to the tar-
get PT model.
recorded to the Memory Unit besides screen data. When the data in the
Memory Unit is written into the NT631/NT631C, make sure that these set-
tings can be adapted to the NT631/NT631C used before transmission.
the DIP switches.
2
Automatic transmission (writing from the Memory
Unit to the PT)
Automatic transmission (writing from the PT to the
Memory Unit)
3
SW1
4
1
OFF
SW2
2
3
Function
4
Factory setting is turned all to off.
Mounting screws
OFF: Not executed
ON: Executed
OFF: Not executed
ON: Executed
Section 3-5